Thermal Finite-Element Model of an Electric Machine Cooled by a Spray

Christian Bergfried,Samaneh Abdi Qezeljeh,Ilia V. Roisman,Herbert De Gersem,Jeanette Hussong,Yvonne Späck-Leigsnering
2024-10-29
Abstract:The need for higher power density in electrical machines require better cooling strategies. Spray cooling is a very promising and relatively simple technology to apply, but involves extremely complicated physics. In this paper, a quasi-3D thermal finite-element model of a stator winding is created, by extrusion of a 2D cross-sectional finite-element model along the winding direction. The possible effects of spray cooling are simulated as a heat flux using an impedance boundary condition at the surface of the winding overhang. The results confirm the beneficial performance of spray cooling. The model indicates that spray cooling may allow a ten times larger power density than for standard air- or water-cooled machines.
Computational Engineering, Finance, and Science
What problem does this paper attempt to address?
The problem that this paper attempts to solve is more effective cooling strategies required for increasing the power density of electric motors. Specifically, the article explores the application of spray - cooling technology in the heat dissipation of electric motors. This is a very promising and relatively simple technology, but it involves extremely complex physical phenomena. ### Main problems 1. **Requirement for increasing power density**: As the demand for electric motors with higher power density increases, better cooling strategies are required to effectively manage the generated heat. 2. **Limitations of existing cooling methods**: Traditional cooling methods (such as water - cooling, oil - cooling and air - cooling) have limited effectiveness in high - power - density electric motors and cannot meet the requirements for efficient cooling. 3. **Application potential of spray - cooling**: As an emerging cooling technology, spray - cooling has the potential to significantly improve the efficiency of thermal management, but its complexity and parametric characteristics need in - depth study. ### Solutions To verify the effectiveness of spray - cooling, the author developed a quasi - three - dimensional (quasi - 3D) thermal finite - element model to simulate the effect of spray - cooling by stretching a two - dimensional cross - sectional finite - element model in the winding direction. The key points of the model include: - **Heat source distribution**: Considered the Joule loss and other heat sources inside the electric motor. - **Boundary conditions**: Used impedance boundary conditions to simulate the effect of spray - cooling. - **Spray - cooling parameters**: Considered key parameters such as the average diameter, velocity, mass flux density and temperature of spray droplets. ### Results and discussion - **Significant cooling effect**: The model results show that spray - cooling can increase the power density of electric motors by more than ten times. - **Uniform temperature distribution**: Spray - cooling can effectively reduce the surface temperature of windings and ensure that the electric motor can still operate stably at high temperatures. - **Wide applicability**: Spray - cooling is not only applicable to electric motors, but can also be applied to other high - power electronic devices and systems. In conclusion, this paper aims to solve the heat dissipation problems faced by high - power - density electric motors by introducing spray - cooling technology, and provides important theoretical basis and technical support for future research and applications.