Abstract:Benefiting from the high critical current density (Jc), single-grain (RE)BCO (where RE = rare earth or Gd) bulks are capable of trapping over 17.6 T magnetic field which is crucial for the application of bulk superconductors. Nevertheless, during field cooling magnetization (FCM), the large mechanical stress induced by Lorentz forces may lead to fracture behavior in the brittle ceramic nature of (RE)BCO materials. Most previous numerical models that adopted simplified homogeneous Jc had difficulty reflecting the real stress/strain situation in high temperature superconductor (HTS) bulks. Based on the proposed modified Jirsa model considering r-z plane Jc inhomogeneity, we investigate the mechanical response of GdBCO bulks manufactured by top-seeded melt growth (TSMG) process. A 2D axisymmetric electromagnetic-thermal-mechanical coupled model is implemented to take into account the dependence of Jc upon mechanical deformation. The simulation results show the electromagnetic-thermal-mechanical response of the r-z plane inhomogeneous Jc model is significantly lower than that obtained by the homogeneous Jc model. This confirms Takahashi's speculation (K Takahashi 2019 Supercond. Sci. Technol. 32 015007) about the mismatch between experimental data and the simulation results of homogeneous Jc model, and suggests the stress levels in the bottom plane of HTS bulk are overestimated by the previous homogeneous Jc model. On top of that, the overall stress level of GdBCO bulk is strongly determined by the magnitude and position of the Lorentz force load, and the stress distribution of inhomogeneous Jc model is mainly concentrated in high Jc regions near top surface, instead of being symmetrically distributed along the z-axis as in homogeneous Jc model. The mechanical response of stainless steel reinforced GdBCO bulk under two different constraint conditions was analyzed and compared. Finally, the coupling effect between the fracture strength variability caused by defects and cracks and the trapped field in GdBCO bulks with r-z plane Jc inhomogeneity is further studied. This study may provide a relatively realistic mechanical response of HTS bulk during FCM, and a novel design consideration for its mechanical reinforcement.

Expression with self-consistent magnetic units for calculation of critical current density using the Bean's Model

Procedures for proper validation of record critical current density claims

Comments on "Procedures for proper validation of record critical current density claims" by Chiara Tarantini and David C. Larbalestier

Self-consistent Modeling of the $I_c$ of HTS Devices: How Accurate do Models Really Need to Be?

Experimental and Simulation Studies of SCIF Considering Non-Uniform Critical Current

Thin superconducting disk with field-dependent critical current: Magnetization and ac susceptibilities

Modelling the mechanics of 32 T REBCO superconductor magnet using numerical simulation

Magnetocaloric Effect and Critical Behavior in Melt-Extracted Gd60Co15Al25microwires (phys. Status Solidi A 9∕2015)

Effective Modeling of Magnitude-Fluctuated Magnetization Dynamics: Dynamic Precursor Effect in Magnets

The Bean model of the critical state in a magnetically shielded superconductor filament

An Advanced Computational Approach for Evaluating Screening-Current-Induced Strain in REBCO HTS Coils Considering Electromagnetic-Mechanical Coupling

Analysis of magnetization induced error field in superconducting magnets

Comparison of J c measurements obtained by magnetisation and transport methods for a GdBCO-Ag bulk

Field and temperature scaling of the critical current density in commercial REBCO coated conductors

Anisotropic Connectivity and its Influence on Critical Current Densities, Irreversibility Fields, and Flux Creep in In-Situ-Processed MgB2 Strands

2-D Model for Calculating Current Density Distribution and Flux-Flow Resistivity of MCP BSCCO-2212 Rod During Quenching Process in Self Field

A formal theory of the conductivity and application to the giant magnetoresistance

Self-field effects upon the critical current density of flat superconducting strips

R-z plane spatial critical current inhomogeneity-induced mechanical response of GdBCO superconducting bulks during field cooling magnetization