Abstract:The present work presents a 2D and 3D modelling of the neutral gas flow in the sub-divertor region of the W7-X. The investigations have been done using the DIVGAS code. The complex 2D and 3D geometries of the divertor components in the sub-divertor region have been considered and the Standard and High-Iota magnetic configurations have been numerically simulated. The main objective of this study is to investigate the dynamics of neutral particles in the sub-divertor region including the effects due to geometry and toroidal and poloidal leakages located at the divertor targets and baffles on the achieved pumping efficiency. A sensitivity analysis has been performed for the effect of various geometrical and flow parameters on the pumping performance, under different plasma scenarios. The considered incoming fluxes in the sub-divertor range between 1020 to 1022 (H2/s). The main conclusions, which can be extracted from the present numerical analysis could be summarized as follows; a large fraction of incoming neutral particle flux i.e. > 70% on the low iota side and > 40% for the high iota side is leaked back to the main divertor region, while higher incoming neutral fluxes facilitate the increase of the pumped flux as well as the decrease of the outflux. It has been estimated that a small fraction ~3-4% of the incoming neutral flux is being pumped via the turbo-molecular pumps. The closure of the toroidal leakages as well as the inclination of the pumping gap panel by 9 o facilitate the increase of the pumped flux, but considering the all the engineering constraints, the latter option seems to be more easy to be implemented. For low incoming neutral fluxes (~1020 H2/s) and for the case of AEH section, free molecular flow conditions are estimated and therefore neutral-neutral collisions could be neglected. For higher incoming neutral fluxes and for both AEH and AEP sections neutral-neutral collisions play a significant role in the flow establishment. A comparison with available experimental measurements of the neutral pressure in the sub-divertor has been performed for Standard and High-Iota plasma discharges. The 3D DIVGAS simulations predict qualitatively the experimental data with relative deviation between 25 and 63%. All the above numerical findings will actively support the optimization of the W7-X particle exhaust, in view of the experimental campaign OP2.

Neutral pressure measurement in TCV tokamak using ASDEX-type pressure gauges

Development of the neutral gas diagnostic system for neutral pressure measurements and gas analysis on the SPARC tokamak

Impact of divertor neutral pressure on confinement degradation of advanced tokamak scenarios at ASDEX Upgrade

Performance of ITER pressure gauges during deuterium operation in the Large Helical Device

Numerical simulation of neutral gas dynamics in the W7-X sub-divertor

Improved Heat and Particle Flux Mitigation in High Core Confinement, Baffled, Alternate Divertor Configurations in the TCV tokamak

DSMC simulations of neutral gas flow in the DTT particle exhaust system

Investigating the influence of divertor baffles on nitrogen-seeded detachment in TCV with SOLPS-ITER simulations and TCV experiments

Verification of lifetime and mechanical load aspects for ITER diagnostic pressure gauges based on ZrC emitter

Effects of neutral gas pressure on calibration parameters of resistive bolometer sensors in fusion devices

Dependence of divertor turbulence on plasma density and current in TCV

Performance assessment of long-legged tightly-baffled divertor geometries in the ARC reactor concept

Commissioning of the Imaging Neutral Particle Analyzer for the ASDEX Upgrade tokamak

Separating the roles of magnetic topology and neutral trapping in modifying the detachment threshold for TCV

Possibilities of Using Active Neutral Particle Diagnostics at the TRT Facility

Performance assessment of a tightly baffled, long-legged divertor configuration in TCV with SOLPS-ITER

A Gas Monitoring Chamber for High Pressure Applications

Measurements of Neutral Density Profiles Using A Deuterium Balmer-Alpha Diagnostic in the C-2 Frc Plasma

Benign termination of runaway electron beams on ASDEX Upgrade and TCV

DEGAS 2 model validation study: comparison of measured and modeled helium and deuterium line emission arising from an external gas puff on Alcator C-Mod

An Overview of Results from the Tcv Tokamak