Abstract:Combining collocated high-rate Global Navigation Satellite Systems (GNSS) and accelerometers produces broadband seismogeodetic displacements. However, accelerometer data must be heavily downweighted due to their baseline errors originating primarily in instrument rotations, and therefore their contribution to seismogeodetic displacements is seriously underestimated. We further introduced a gyroscope into this classic seismogeodesy to mitigate baseline errors and formulated advanced six-degree-of-freedom (6-DOF) seismogeodesy without undervaluing accelerometer data. A shake table holding one GNSS antenna, four accelerometers, and one gyroscope was used to simulate waveforms from the 2010 Mw 7.2 El Mayor-Cucapah earthquake. We found that the displacements derived from the 6-DOF seismogeodesy were up to 68% more accurate than those from the classic seismogeodesy over 0.04-0.4 Hz. Moreover, broadband rotations containing the permanent components were also generated, which were unachievable by integrating gyroscope data. We believe that the 6-DOF seismogeodesy is capable of improving both source rupture studies of large earthquakes and high-rise monitoring under strong seismic waves. Plain Lauguage Summary The faulting mechanism of large earthquakes has always been an enigma to the seismology community. One important reason is that we cannot measure accurately the low-frequency (e.g., <0.1 Hz) displacements at near-source stations using existing techniques. In particular, seismometer recovered low-frequency displacements are normally biased and incomplete due to intrinsic instrument limitations; Global Navigation Satellite Systems is able to obtain unbiased broadband (e.g., 0-5 Hz) displacements, but they are over 2 orders of magnitude noisier than seismometer measurements. We therefore develop an advanced technique that combines collocated Global Navigation Satellite System receivers, accelerometers, and gyroscopes to capture highly accurate earthquake-induced displacements and also rotations, spanning the frequencies from 0 to tens of hertz. We demonstrate that the accuracy of low-frequency displacements can be improved by up to 68% in contrast to traditional measuring techniques, and the permanent rotations can also be recovered, which can never be achieved by only inertial sensors (i.e., gyroscopes and accelerometers). We believe that this new technique can assist in deepening our understanding of the rupture process of large earthquakes, and the broadband rotations have the potential to unveil more unknowns about earthquake sources and Earth media beyond our present knowledge. We can get more prepared for future destructive earthquakes.

Paraxial micro earthquake: a natural effective multi-purpose check shot for downhole earthquake monitoring

Using Microseismic Events to Improve the Accuracy of Sensor Orientation for Downhole Microseismic Monitoring

High-resolution borehole earthquake monitoring at San Andreas Fault Observatory at Depth, Parkfield, California

Microseismic Event Location Using an Inverse Method of Joint P–S Phase Arrival Difference and P-wave Arrival Difference in a Borehole System

Experimental Measurements of Seismoelectric Signals in Borehole Models

Receiver Orientation and Event Back-Azimuth Estimation for Downhole Microseismic Monitoring Using a Probabilistic Method Based on P-wave Polarization

Master event based backazimuth estimation and its application to downhole microseismic monitoring

Downhole Microseismic Monitoring for Low Signal-To-Noise Ratio Events

Six-Degree-of-Boradband Seismogeodesy by Combining Collocated High-Rate GNSS, Accelerometers, and Gyroscopes

Testing of a Permanent Orbital Surface Source and Distributed Acoustic Sensing for Monitoring of Unconventional Reservoirs: Preliminary Results from the Eagle Ford Shale

Downhole Microseismic Monitoring Using Time-Division Multiplexed Fiber-Optic Accelerometer Array

Earthquake Monitoring and High-Resolution Velocity Tomography for the Central Longmenshan Fault Zone by a Temporary Dense Seismic Array

Back azimuth constrained double-difference seismic location and tomography for downhole microseismic monitoring

Application of a new type of six-component seismometer for underground anomaly detection

A new passive seismic method based on seismic interferometry and multichannel analysis of surface waves

Acoustic emission source location from P-wave arrival time corrected data and virtual field optimization method

Microseismic Event Location with Dual Vertical DAS Arrays: Insights from the FORGE 2022 Stimulation

Using distributed acoustic sensing to characterize unconventional reservoirs via perforation-shot triggered P waves

Low-magnitude Seismicity with a Downhole Distributed Acoustic Sensing Array -- examples from the FORGE Geothermal Experiment

Seismic Magnitude Estimation Using Low-Frequency Strain Amplitudes Recorded by DAS Arrays at Far-Field Distances

Using Active Source to Monitor Velocity Variation in Shallow Sediment Caused by the Wenchuan Earthquake