Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Dispersive wave propagation in disordered flexible fibers enhances stress attenuation

Suppression of Electromechanical Instability in Fiber-Reinforced Dielectric Elastomers

An Investigation on triaxial compression of flexible fiber packings

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Local Resonant Attenuation of Stress Waves in Particulate Composites.

Breakage of Wet Flexible Fiber Agglomerates Impacting a Plane

The Stress-Microstructure Relationship in an Evolving Mixing Layer of Fiber Suspensions

Discrete Element Method Models of Elastic and Elastoplastic Fiber Assemblies

Stress-wave propagation in multilayered and density-graded viscoelastic medium

Elastic wave velocities in finitely pre-stretched soft fibers

Experimental and Numerical Investigations on the Stress Waves Propagation in Strain-Hardening Fiber-Reinforced Cementitious Composites: Stochastic Analysis Using Polynomial Chaos Expansions

Yielding and hardening of flexible fiber packings during triaxial compression

Shockwave dissipation by interface-dominated porous structures

Stress-induced anisotropy in granular materials: fabric, stiffness, and permeability

Ultra-long-range force transmission in fiber networks enabled by multiaxial mechanical coupling

Stress-optic effect in YAP crystal optical fiber

Strong size-dependent stress relaxation in electrospun polymer nanofibers

Anisotropic nonlinear elasticity in a spherical bead pack: influence of the fabric anisotropy

Stress dependence of elastic wave dispersion and attenuation in fluid-saturated porous layered media

Study of the effect of lengths on the propagation mechanism of interconnected cracks under impact loads

Propagation of Nonlinear Waves in Graded Flexible Metamaterials