Abstract:The Outer Tracker of the Compact Muon Solenoid (CMS), one of the large experiments at the CERN Large Hadron Collider, will consist of about 13,200 modules, each built up of two silicon sensors. The modules and support structures include thousands of parts that contribute to positioning and cooling the sensors during operation at -30 °C. These parts should be low mass while featuring high thermal conductivity, stiffness and strength. Their thermal expansion coefficient should match that of silicon to avoid deformations during cooling cycles. Due to their unique thermal and mechanical properties, aluminium-carbon fibre (Al/Cf) Metal Matrix Composites are the material of choice to produce such light and stable thermal management components for High Energy Physics detectors. For the CMS Outer Tracker, about 500,000 cm3 of Al/Cf raw material will be required to be produced through a reliable process to guarantee consistent properties throughout parts manufacturing. Two Al/Cf production routes are currently considered: liquid casting by gas-pressure infiltration and a powder metallurgy process based on continuous semi-liquid phase sintering. The dimensional stability of the resulting material is of paramount importance. Irreversible change of shape may be induced by moisture adsorption and the onset of galvanic corrosion at the discontinuous interfaces between Cf and Al. This paper presents the results of an extensive investigation through Computed Microtomography, direct microscopical investigations, analysis of the interfaces and metrology measurements aimed at comparing and interpreting the response to different environments of the respective products. The results obtained confirm the suitability of the two investigated Al/Cf MMCs for application to components of the CMS Outer Tracker, requiring tight geometrical control and microstructural stability over time. However, for PM parts sintered through the semi-liquid phase process, a multilayered protective noble metal coating is necessary the make them impervious to moisture, allowing dimensional stability to be guaranteed and the onset of corrosion phenomena to be avoided, while the product obtained by gas-pressure infiltration has shown less sensitive even to extreme temperature-humidity cycles and may be used uncoated.

Advanced fabrication process for particle absorbers of highly pure electroplated gold for microcalorimeter applications

Magnetic microcalorimeter with paramagnetic temperature sensors and integrated dc-SQUID readout for high-resolution x-ray emission spectroscopy

Magnetic microcalorimeters for primary activity standardization within the EMPIR project PrimA-LTD

Cryogenic particle detection based on magnetic microcalorimeters for rare event searches

Characterization of low temperature metallic magnetic calorimeters having gold absorbers with implanted $^{163}$Ho ions

Assessment of Two Advanced Aluminium-Based Metal Matrix Composites for Application to High Energy Physics Detectors

Magnetic Shield Design and Simulation Optimization of Metallic Magnetic Calorimeter in Ultra-Low Temperature Working State

Fabrication of X-ray Microcalorimeter Focal Planes Composed of Two Distinct Pixel Types

Multichannel read-out for arrays of metallic magnetic calorimeters

High-Rate Capable Floating Strip Micromegas

Microcalorimeter Absorber Optimization for ATHENA and LEM

MMC-based low-temperature detector system of the AMoRE-Pilot experiment

Performance of a Highly Granular Scintillator-SiPM Based Hadron Calorimeter Prototype in Strong Magnetic Fields

Fabrication of High Aspect Ratio Micro-Penning-Malmberg Gold Plated Silicon Trap Arrays

Cryogenic micro-calorimeters for mass spectrometric identification of neutral molecules and molecular fragments

Signal Formation Processes in Micromegas Detectors and Quality Control for large size Detector Construction for the ATLAS New Small Wheel

Design and optimization of a hadronic calorimeter based on micropattern gaseous detectors for a future experiment at the Muon Collider

Enhancing Magnetic Micro- and Nanoparticle Separation with a Cost-Effective Microfluidic Device Fabricated by Laser Ablation of PMMA

R&D status for an innovative crystal calorimeter for the future Muon Collider