Why Static Friction Decreases From Single to Multi-asperity Contacts

Liang Peng,Thibault Roch,Daniel Bonn,Bart Weber
2024-09-06
Abstract:The key parameter for describing frictional strength at the onset of sliding is the static friction coefficient. Yet, how the static friction coefficient at the macroscale emerges from contacting asperities at the microscale is still an open problem. Here, we present friction experiments in which the normal load was varied over more than three orders of magnitude, so that a transition from a single asperity contact at low loads to multi-asperity contacts at high loads was achieved. We find a remarkable drop in static friction coefficient with increasing normal load. Using a simple stick-slip transition model we identify the presence of pre-sliding and subcritical contact points as the cause of smaller static friction coefficient at increased normal loads. Our measurements and model bridge the gap between friction behavior commonly observed in atomic force microscopy (AFM) experiments at microscopic forces, and industrially relevant multi-asperity contact interfaces loaded with macroscopic forces.
Soft Condensed Matter
What problem does this paper attempt to address?
The problem that this paper attempts to solve is: **How does the macroscopic static friction coefficient change with the change of normal load when the contact interface transitions from a single contact point to multiple contact points?** Specifically, the author experimentally observed that under different normal loads, the static friction coefficient significantly decreases as the normal load increases. This phenomenon is manifested on the macroscopic scale as the static friction coefficient of the multi - contact - point interface being lower than that of the single - contact - point interface. ### Main research content 1. **Experimental design**: - Use a rheometer (DSR 502, Anton Paar) and an analytical balance (Quintix, Sartorius) to conduct friction experiments. - The experiments are carried out in a humidity - controlled room with a relative humidity stabilized at 0.8%. - By changing the stiffness of the silicon cantilever, precisely control the normal load range from 0.1 mN to 100 mN. - Adopt the Slide - Hold - Slide (SHS) measurement procedure to record the maximum static friction force \( F_S \) and the average dynamic friction force \( F_D \) at the time of sliding restart. 2. **Experimental results**: - The static friction coefficient \( \mu_S \) gradually decreases as the normal load increases. - The change trend of the static friction coefficient at the single - contact - point nanoscale is consistent with that of the multi - contact - point interface. 3. **Theoretical model**: - Propose a simple stick - slip transition model, assuming that the macroscopic friction force is the sum of all microscopic interface shear forces. - The model predicts the distribution of the total friction force under different normal loads based on the local normal stress distribution calculated by elastic contact. - Three types of contact points are defined in the model: critical, pre - sliding, and sub - critical. - The critical contact point remains stationary when the maximum static friction force is reached; the pre - sliding contact point has already slipped; the sub - critical contact point starts to slip due to the redistribution of friction force after the critical contact point slips. 4. **Conclusion**: - As the normal load increases, the proportion of pre - sliding and sub - critical contact points increases, resulting in a decrease in the macroscopic static friction coefficient. - This phenomenon can be successfully explained by the stick - slip transition model, and the results predicted by the model are in good agreement with the experimental data. - The research results are of great significance for understanding the friction behavior from single - contact - point to multi - contact - point interfaces, especially in precision positioning and industrial applications. ### Formula summary - Static friction coefficient: \[ \mu_S=\frac{F_S}{N} \] - Dynamic friction coefficient: \[ \mu_D = \frac{F_D}{N} \] - Friction reduction ratio: \[ \text{Friction reduction ratio}=\frac{\mu_S}{\mu_D}=\frac{F_S}{F_D} \] Through these experiments and models, the author reveals the mechanism of the decrease in the static friction coefficient of the multi - contact - point interface under high normal loads, providing new insights into understanding the friction behavior of complex contact interfaces.