Abstract:Tin selenide (SnSe) and tin sulfide (SnS) have recently attracted particular interest due to their great potential for large-scale thermoelectric applications. A complete prediction of the thermoelectric performance and the understanding of underlying heat and charge transport details are the key to further improvement of their thermoelectric efficiency. We conduct comprehensive investigations of both thermal and electrical transport properties of SnSe and SnS using first-principles calculations combined with the Boltzmann transport theory. Due to the distinct layered lattice structure, SnSe and SnS exhibit similarly anisotropic thermal and electrical behaviors. The cross-plane lattice thermal conductivity κL is 40–60% lower than the in-plane values. Extremely low κL is found for both materials because of high anharmonicity, while the average κL of SnS is ∼8% higher than that of SnSe from 300 to 750 K. It is suggested that nanostructuring would be difficult to further decrease κL because of the short mean free paths of dominant phonon modes (1–30 nm at 300 K), while alloying would be efficient in reducing κL considering that the relative κL contribution (∼65%) of optical phonons is remarkably large. On the electrical side, the anisotropic electrical conductivities are mainly due to the different effective masses of holes and electrons along the a, b, and c axes. This leads to the highest optimal ZT values along the b axis and lowest ones along the a axis in both p-type materials. However, the n-type ones exhibit the highest ZTs along the a axis due to the enhancement of power factor when the chemical potential gradually approaches the secondary conduction band valley that causes significant increase in electron mobility and density of states. Owing to the larger mobility and smaller κL along the given direction, SnSe exhibits larger optimal ZTs compared with SnS in both p- and n-type materials. For both materials, the peak ZTs of n-type materials are much higher than those of p-type ones along the same direction. The predicted highest ZT values at 750 K are 1.0 in SnSe and 0.6 in SnS along the b axis for the p-type doping, while those for the n-type doping reach 2.7 in SnSe and 1.5 in SnS along the a axis, rendering them among the best bulk thermoelectric materials for large-scale applications. Our calculations show reasonable agreements with the experimental results and quantitatively predict the great potential in further enhancing the thermoelectric performance of SnSe and SnS, especially for the n-type materials.

Thermoelectric Properties of Type-I and Type-II Nodal Line Semimetals: A Comparative Study

Enhanced Anomalous Nernst Effect by Tuning the Chemical Potential in the Topological Kagome Ferromagnet Fe3Sn2

Thin films of topological nodal line semimetals as a candidate for efficient thermoelectric converters

Optical and thermoelectric properties of new Janus ZnMN2 (M = Ge, Sn, Si and N = S, Se, Te) monolayers: a first-principles study

Thermoelectric performance of Bi2Sn2Te6 monolayer with ultralow lattice thermal conductivity induced by hybrid bonding properties: A theoretical prediction

Thermoelectric performance of classical topological insulator nanowires

Emergence of promising n-type thermoelectric material through conductive network and strong phonon softening

Na/Bi-co-doping and Heterogeneous Interfaces Leading to Enhanced Thermoelectric Performance of P-Type Mg3Sb2-based Zintls

Topological Insulator VxBi1.08-xSn0.02Sb0.9Te2S as a Promising n-type Thermoelectric Material

Thermoelectric properties of semiconducting materials with parabolic and pudding-mold band structures

Fine-Tuning Bi2Te3-Copper Selenide Alloys Enables an Efficient n-Type Thermoelectric Conversion

Thermoelectric and lattice dynamics properties of layered MX (M = Sn, Pb; X = S, Te) compounds

Tailoring Thermoelectric Performance of n-type Bi2Te3 through Defect Engineering and Conduction Band Convergence

Unique Topological Nodal Line States and Associated Exceptional Thermoelectric Power Factor Platform in Nb3GeTe6 Monolayer and Bulk.

Giant thermoelectric effect governed by unique two-dimensional electronic structure and strong anharmonicity in layered nitrides

Grading studies for efficient thermoelectric devices using combined 1D material and device modeling

Engineering of charge carriers via a two-dimensional heterostructure to enhance the thermoelectric figure of merit.

One–One Correspondence between n-Type SnTe Thermoelectric and Topological Phase Transition

Band Modification and Localized Lattice Engineering Leads to High Thermoelectric Performance in Ge and Bi Codoped SnTe–AgBiTe2 Alloys

First-principles study of anisotropic thermoelectric transport properties of IV-VI semiconductor compounds SnSe and SnS