Nanostructured Fe2O3/CuxO Heterojunction for Enhanced Solar Redox Flow Battery Performance

Jiaming Ma,Milad Sabzehparvar,Ziyan Pan,Giulia Tagliabue
2024-08-01
Abstract:Solar redox flow batteries (SRFB) have received much attention as an alternative integrated technology for simultaneous conversion and storage of solar energy. Yet, the photocatalytic efficiency of semiconductor-based single photoelectrode, such as hematite, remains low due to the trade-off between fast electron hole recombination and insufficient light utilization, as well as inferior reaction kinetics at the solid/liquid interface. Herein, we present an {\alpha}-Fe2O3/CuxO p-n junction, coupled with a readily scalable nanostructure, that increases the electrochemically active sites and improves charge separation. Thanks to light-assisted scanning electrochemical microscopy (Photo-SECM), we elucidate the morphology-dependent carrier transfer process involved in the photo-oxidation reaction at a {\alpha}-Fe2O3 photoanode. The optimized nanostructured is then exploited in the {\alpha}-Fe2O3/CuxO p-n junction, achieving an outstanding unbiased photocurrent density of 0.46 mA/cm2, solar-to-chemical (STC) efficiency over 0.35% and a stable photocharge-discharge cycling. The average solar-to-output energy efficiency (SOEE) for this unassisted {\alpha}-Fe2O3-based SRFB system reaches 0.18%, comparable to previously reported DSSC-assisted hematite SRFBs. The use of earth-abundant materials and the compatibility with scalable nanostructuring and heterojunction preparation techniques, offer promising opportunities for cost-effective device deployment in real-world applications.
Chemical Physics
What problem does this paper attempt to address?
The paper aims to address the issue of low photoelectric conversion efficiency encountered in practical applications of solar redox flow batteries (SRFB). Specifically, the paper proposes a nanostructure-based α-Fe₂O₃/CuₓO heterojunction to improve photoelectrochemical performance. By optimizing the nanostructure and designing the heterojunction, researchers can significantly enhance charge separation and increase electrochemical active sites, thereby achieving higher photocurrent density and solar-to-chemical (STC) conversion efficiency. Additionally, the system demonstrates stable charge-discharge cycling performance, providing the potential for developing more cost-effective practical applications. The focus of the paper is on overcoming the trade-off between light absorption and charge separation in traditional single photoelectrode semiconductor materials (such as hematite) through nanotechnology and heterojunction design.