Ultrahigh pyroelectricity in monoelemental 2D tellurium

Hari Krishna Mishra,Ayushi Jain,Dalip Saini,Bidya Mondal,Chandan Bera,Shanker Ram,Dipankar Mandal

2024-07-27

Abstract:We report an ultrahigh pyroelectric response in van der Waals bonded layers of two-dimensional (2D) tellurium (Te) nanosheets (thickness, d = 4 to 5 nm) at periodic on-off temperature oscillations. For the first time a large pyroelectric coefficient, Pc ~ 3 mC.m-2.K-1, is observed which is eightfold higher than the traditional state-of-the-art pyroelectrics (lead zirconate titanate, PZT). The first-principles calculations point out that the breakdown of centro-symmetry in the 1-3 Te-layers (P-3m1 space group) of a non-centrosymmetry (higher-order symmetry of C2 space group) on an angular twist in the Te-Te bonds of an exotic electronic state in 2D Te. The angular Te-Te twisting elicits a surface-enhanced Raman band at 101 cm-1 (absent in bulk Te). The stimulation of the Born effective charge, in-plane piezoelectricity and thermal expansion coefficient are shown to tailor the large pyroelectricity. Thus, 2D Te nanosheets present a new paradigm for the wide application of pyroelectric materials for developing thermal energy-based flexible electronics.

Materials Science,Applied Physics

What problem does this paper attempt to address?

The paper mainly addresses the following issues:

1. **Development of new efficient thermoelectric conversion materials**: Researchers have discovered that a single-element two-dimensional (2D) Tellurium (Te) material exhibits ultra-high pyroelectric performance. This material can convert thermal energy into electrical energy during periodic temperature changes.

2. **Exploration of the pyroelectric mechanism of 2D Tellurium materials**: Through first-principles calculations, the microscopic mechanism of pyroelectricity in 2D Tellurium materials was revealed. Specifically, when the Tellurium atomic layers undergo a specific angular twist, it breaks the centrosymmetry, resulting in a significant pyroelectric effect.

3. **Optimization of material structure to improve pyroelectric coefficient**: Researchers, through theoretical calculations and experimental verification, determined that 2D Tellurium materials with a specific thickness (e.g., three atomic layers) can achieve a very high pyroelectric coefficient (\(P_c \approx 3 \times 10^3\) μC·m\(^{-2}\)·K\(^{-1}\)), a value much higher than traditional pyroelectric materials such as lead zirconate titanate (PZT).

4. **Preparation of high-performance pyroelectric nanogenerators**: Based on the above findings, researchers have prepared a pyroelectric nanogenerator (PyNG) based on 2D Tellurium materials. This device can operate at room temperature and exhibits excellent energy conversion efficiency.

5. **Evaluation of the comprehensive performance indicators of the new material**: By studying parameters such as spontaneous polarization, Born effective charge, in-plane piezoelectric coefficient, and thermal expansion coefficient, it was demonstrated that 2D Tellurium materials have the potential to be high-performance pyroelectric materials.

In summary, this research not only demonstrates the potential of 2D Tellurium as a new pyroelectric material but also delves into its internal mechanisms and successfully prepares a pyroelectric nanogenerator with high conversion efficiency, providing a new direction for the development of future flexible electronic devices.