Abstract:Piezoelectric devices based on high-temperature stable single crystals are of increasing interest due to a wide range of potential applications, such as actuators and resonant gravimetric sensors. The latter require highly accurate resonant-frequency measurements at temperatures as high as 1000 °C, and this can only be achieved with narrow resonance peaks and correspondingly low acoustic loss at these temperatures. Relevant atomistic defects in langasite (La 3 Ga 5 SiO 14 , LGS) and catangasite (Ca 3 TaGa 3 Si 2 O 14 , CTGS) are reviewed with respect to their impact on electrical conductivity and acoustic loss. The focus on these crystals also enables a comparison of electroacoustic properties of partially disordered (LGS) and ordered (CTGS) crystals and the formulation of approaches for reducing acoustic loss and enhancing device performance. Starting with defect chemistry models for LGS and CTGS, electrical conductivities as a function of temperature and oxygen partial pressure are considered. One result of this analysis is that contributions of oxygen ions to the total conductivity are determined to be relatively small in the studied crystals. Temperature-dependent acoustic loss of LGS and CTGS crystals is also studied. Two independent techniques, contact resonant piezoelectric spectroscopy, and a contactless tone-burst excitation technique, are applied. Contributions to the measured acoustic loss are determined by fitting loss-related functions for point defects and conductivity-related relaxations. The extracted fit parameters, in particular the activation energies of the processes, are discussed and compared with that of the electrical conductivity. The losses are caused by a superposition of several mechanisms including conductivity-related relaxations, point-defect relaxations and intrinsic phonon-phonon loss. The long-term stability of the crystals is also evaluated at 1000 °C with respect to fundamental materials properties including electrical conductivity and resonant frequency. After one year of thermal treatment, the resonance frequency of CTGS resonators from different crystal sources is found to decrease by no more than 0.4 %. Thus, the applicability of CTGS as a piezoelectric resonator that operates for long periods at extreme temperatures, such as a resonant nanobalance, is demonstrated. Application examples to be presented include resonant nanobalances for in-situ monitoring of non-stoichiometry and phase transformations in thin films during growth at high temperatures. In this context, the key application properties of the sensors at high temperatures, such as mass sensitivity and resolution, are discussed. As an application example, the attached figure shows the oxygen non-stoichiometry x of thin praseodymium-cerium oxide films (Pr 0.1 Ce 0.9 O 2-x ) at 700 °C as a function of oxygen partial pressure determined by LGS and CTGS nanobalances, which agrees very well with literature data (chemical capacitance: D. Chen et al., Chem. Mater. 2014, 26, 22, 6622–6627). Figure 1

Low Temperature Properties of Low-Loss Macroscopic Lithium Niobate Bulk Acoustic Wave Resonators

Experimental Study of Periodically Poled Piezoelectric Film Lithium Niobate Resonator at Cryogenic Temperatures

Surface Modification and Coherence in Lithium Niobate SAW Resonators

High frequency lithium niobate film-thickness-mode optomechanical resonator

Upconversion of Phonon Modes into Microwave Photons in a Lithium Niobate Bulk Acoustic Wave Resonator Coupled to a Microwave Cavity

Minimally-diffracting quartz for ultra-low temperature surface acoustic wave resonators

High-Temperature Piezoelectric Resonators: Electroacoustic Properties and Applications of Langasite-Type Crystals

High speed surface acoustic wave and laterally excited bulk wave resonator based on single-crystal non-polar AlN film

Investigation on the temperature coefficient of frequency performance of LiNbO3 on quartz and glass surface acoustic wave resonators

Thin-Film Lithium Niobate Acoustic Resonator with High Q of 237 and k2 of 5.1% at 50.74 GHz

Surface acoustic wave resonators on thin film piezoelectric substrates in the quantum regime

Niobate-on-Niobate Resonators with Aluminum Electrodes

Low-loss waveguides on Y-cut thin film lithium niobate: towards acousto-optic applications

Coherent Acoustic Phonons in Plasmonic Nanoparticles: Elastic Properties and Dissipation at Low Temperatures

Near stoichiometric lithium niobate crystal with dramatically enhanced piezoelectric performance for high temperature acceleration sensing

High-temperature electrical conductivity in piezoelectric lithium niobate

Spurious-Free Lithium Niobate Bulk Acoustic Resonator for Piezoelectric Power Conversion

Lithium Niobate MEMS Antisymmetric Lamb Wave Resonators with Support Structures

Single Crystal Bulk Acoustic Resonator for 5 GHz and High-Power Applications

6 Mhz Baw Resonators Fabricated Using New Piezoelectric Crystals Prca4o(Bo3)(3) and Ndca4o(Bo3)(3)

Free-space coupling and characterization of transverse bulk phonon modes in lithium niobate in a quantum acoustic device