Abstract:The mission of an unmanned air vehicle (UAV) tethered to a small unmanned surface vehicle (USV) is considered. As opposed to the majority of existing tethered UAV work, which assumes a taut tether, this paper addresses the challenge of tether management for a slack, hanging tether in a dynamic ocean environment up to sea state 4 on the Douglas scale. A prototype smart reel system for a UAV–USV team was designed and experimentally validated in controlled and uncontrolled dynamic environments. A reference model for tether control based on static catenary cable theory was extended and shown to be valid through the entire operational envelop. A Kalman filter was developed to fuse slow (4 Hz) differential GPS (dGPS) relative position measurements with fast (100 Hz) inertial measurements, to output a 100 Hz estimate of relative position, relative velocity, and inertial sensor bias. A relative velocity‐based gain‐scheduled proportional‐derivative (PD) controller was developed, and demonstrated robustness to heave, pitch, and roll motion of the USV. Experimental testing with a UAV surrogate showed successful decoupling of heave motion from the UAV altitude in a controlled indoor environment. Taut tether control, in contrast, exhibited 12 times more tether tension at the UAV compared to the controller proposed here. The performance of the tuned controller with feedback from the Kalman filter exhibited minimal deviation from static catenary cable theory during the dynamic experiments. Indoor flight testing showed the developed reference model and controller essentially decoupled the dynamic motion of the USV from that of the UAV; the measured deflections of the UAV altitude and position essentially matched that of untethered flight. Outdoor flights validated the effectiveness of the controller in an unknown dynamic environment, for a larger relative position between the UAV and USV, using the dGPS Kalman filter solution to measure relative position. Initial experimental results look promising for continued on‐water testing of hanging‐tether UAV/USV teams.

An Optimal Control Framework for Airborne Wind Energy Systems with a Flexible Tether

Autonomous Take-Off and Flight of a Tethered Aircraft for Airborne Wind Energy

Real-time Optimization and Adaptation of the Crosswind Flight of Tethered Wings for Airborne Wind Energy

Automatic crosswind flight of tethered wings for airborne wind energy: modeling, control design and experimental results

An optimal reeling control strategy for pumping airborne wind energy systems without wind speed feedback

Autonomous take-off and landing of a tethered aircraft: a simulation study

Automatic Circular Take-off and Landing of Tethered Motorized Aircraft

Floating wind turbine control optimization

Safety-Aware Hybrid Control of Airborne Wind Energy Systems

Enhancing Control System Resilience for Airborne Wind Energy Systems Through Upset Condition Avoidance

Control of a Rigid Wing Pumping Airborne Wind Energy System in all Operational Phases

Automatic Retraction and Full Cycle Operation for a Class of Airborne Wind Energy Generators

A New Nonsmooth Optimal Control Framework for Wind Turbine Power Systems

Fully-passive tethered flapping airfoil to harvest high-altitude wind energy

Variable-pitch power regulation of tethered-wing systems based on robust gain-scheduling H-infinity control

Autonomous hanging tether management and experimentation for an unmanned air‐surface vehicle team

Modular Adaptive Aerial Manipulation under Unknown Dynamic Coupling Forces

Wing Deformation of an Airborne Wind Energy System in Crosswind Flight Using High-Fidelity Fluid–Structure Interaction

A Small-Scale Prototype to Study the Take-Off of Tethered Rigid Aircrafts for Airborne Wind Energy

Flight control of tethered kites in autonomous pumping cycles for airborne wind energy

Drag-Mitigating Dynamic Flight Path Design and Sensitivity Analysis for an Ultra-Long Tether Underwater Kite