Abstract:Mass spectrometry is widely used analytical technique due to its high specificity for analyte identification as well as its high sensitivity.A custom mass spectrometer instrument based on a cylindrical ion trap (CIT)was built and its working parameters were optimized.An electron ionization(EI)source was chosen for experimental simplic-ity and availability of standard EI spectral libraries.The custom designed CIT was con-sisted of a pair of endcap electrodes and a ring electrode(r0=1 0 mm,z0=8.9 7 mm).A high voltage RF signal which needed to be applied directly to the ring electrode to pro-duce appropriate quadrupole was initially created by an RF generator at low voltage.A power amplifier and a voltage amplifier circuit were used to amplify to an appropriate power level.The boundary ej ection method was used.An electron multiplier,a current amplifier and NI PCIe data acquire card made up the ion detection and data acquisition system.The EI source,CIT and electron multiplier (EM)were mounted in a rail which ensured they were aligned precisely.The software designed in LabVIEW controlled the timing of the whole system.Several MATLAB programs were written to perform post-processing operations on saved MS data files.In order to obtain the optimal working pa-rameters,different values of filament current,bias voltage of EI,background pressure, voltage on the EM detector and mass scan rate were tested in the vacuum chamber.The trends of spectral peak were obtained:1)Signal intensity increased with the heating current supplied to the EI source due to the increased electron emission at higher tem-perature;2)The bias voltage of EI affected the kinetic energy of ions.With the increas-ing of the voltage,the signal intensity increased.When the voltage increased to a cer-tain range,the intensity fluctuated.In most common EI sources,a kinetic energy of 70 V was used.So the bias voltage was set as 70 V;3)Both signal intensity and resolution increased when background pressure was increased from 1×10-4to 6×10-4Pa.When the pressure further increased,the performance decreased;4)Signal intensity was pro-portional to the voltage on the EM detector.Considering the signal intensity and the lifetime of EM,a voltage of 1.75 kV was used;5)Mass scan rate had influence on the signal intensity and resolution.When the scan rate was too fast,the various ions bunched together and increased the signal intensity but reduced the resolution.Slowing the scan rate caused the peaks to spread apart resulting in increased resolution.By using the optimized parameters,several experiments were carried out.The results showed that the mass spectrum was accurate and the resolution was about 300.The MS plat-form performed well which laid a foundation of further research.To further improve resolution,axial RF will be applied to the endcap electrode to perform resonance ej ection in the following work and based on this platform the operation method for high-pressure MS will be explored.

Phase-Imaging Ion-Cyclotron-Resonance Mass Spectrometry with the Canadian Penning Trap at CARIBU

Phase-Imaging Ion-Cyclotron-Resonance technique at the JYFLTRAP double Penning trap mass spectrometer

Applications of Machine Learning and Neural Networks for FT-ICR Mass Measurements with SIPT

Status and Outlook of CHIP-TRAP: the Central Michigan University High Precision Penning Trap

Collision-Induced Dissociation at TRIUMF's Ion Trap for Atomic and Nuclear science

Mass measurements of neutron-rich nuclides using the Canadian Penning Trap to inform predictions in the $r$-process rare-earth peak region probe the $r$-process rare-earth peak

First Use of High Charge States for Mass Measurements of Short-lived Nuclides in a Penning Trap

Verifying the accuracy of the TITAN Penning-trap mass spectrometer

Highly charged ions in Penning traps, a new tool for resolving low lying isomeric states

Preliminary Results of Positive Ion Mass Spectrometry Based on a 2.45 GHz ECR Ion Source and a Non-Metallic Gas Target

The Ramsey method in high-precision mass spectrometry with Penning traps: Experimental results

Rectilinear ion trap: concepts, calculations, and analytical performance of a new mass analyzer.

Mass measurements near the $r$-process path using the Canadian Penning Trap mass spectrometer

Rectilinear Ion Trap Mass Spectrometer with Atmospheric Pressure Interface and Electrospray Ionization Source.

New Progress of a 2.45 GHz ECR Ion Source for Carbon Positive Ion Mass Spectrometry

Ion Trap Mass Analysis at High Pressure: an Experimental Characterization.

Calibration and simulation of ionization signal and electronics noise in the ICARUS liquid argon time projection chamber

Recent results on the low-pressure GEM-based TPC at an Accelerator Mass Spectrometer

The TRAPSENSOR Facility: an Open-Ring 7-Tesla Penning Trap for Laser-Based Precision Experiments

Nondestructive Ion Trap Mass Analysis at High Pressure

Research on Key Techniques of Cylindrical Ion Trap Mass Spectrometer and Parameters Optimization