Abstract:Aspects of predictions of activation-energy asymptotics concerning the dependence of the burning velocity on the equivalence ratio are examined here through both asymptotic analyses and numerical computation. In typical hydrocarbon-air flames, the burning velocity achieves its maximum value for fuel-rich mixture, the cause being generally attributed to the effects of detailed chemical kinetics and unequal diffusivities of the reactants. The present results demonstrate the possibility of this attribute of the burning velocity occurring even when these two effects are absent. This is accomplished by parametrically studying the burning-velocity formula valid for all equivalence ratios under the conditions specified in the title of this article, with special attention paid to implications for hydrocarbon-air flames.
What problem does this paper attempt to address?
This paper aims to explore and analyze the two - reaction one - step activation - energy asymptotics of the dependence of the burning velocity on the equivalence ratio when the Lewis number is 1 under steady - state, adiabatic, and planar flame conditions. Specifically, through asymptotic analysis and numerical calculation, the paper studies the relationship between the burning velocity and the equivalence ratio, with particular attention to the significance of this relationship in fuel - air mixtures.
### Main problems
1. **Maximum burning velocity**: In typical hydrocarbon - air flames, the burning velocity usually reaches its maximum in fuel - rich mixtures. This phenomenon is usually attributed to detailed chemical kinetic effects and unequal reactant diffusivities. However, the research in this paper shows that even without these effects, the burning velocity may still reach its maximum under fuel - rich conditions.
2. **Application of activation - energy asymptotics (AEA)**: Through parametric studies, the paper verifies the applicability of the one - step activation - energy asymptotics at different equivalence ratios, especially for methane - air mixtures. It is found that when using the one - step Arrhenius chemical approximation, the predicted maximum burning velocity may occur in fuel - rich conditions far from the stoichiometric condition, which is inconsistent with the experimental results.
### Research methods
- **Asymptotic analysis**: Through the asymptotic analysis method, the formula for the relationship between the burning velocity and the equivalence ratio is derived.
- **Numerical calculation**: The numerical integration method is used to verify the results of the asymptotic analysis and compare the changes in the burning velocity at different equivalence ratios.
### Key formulas
1. **Temperature normalization variable**:
\[
\tau=\frac{T - T_0}{T_{\infty}-T_0}
\]
where \(T_0\) and \(T_{\infty}\) represent the temperatures of the fresh mixture and the combustion gas respectively.
2. **Zel’dovich number**:
\[
\beta = \alpha\frac{E}{RT_{\infty}}
\]
where \(E\) is the activation energy, \(R\) is the universal gas constant, and \(\alpha\) is the heat release.
3. **Characteristic value of the burning rate**:
\[
\Lambda=\left(\frac{BD_T}{S_L^2}\right)e^{-\frac{E}{RT_{\infty}}}
\]
4. **Differential equation**:
\[
\frac{d^2\tau}{dx^2}=\frac{d\tau}{dx}-\Lambda(1 - \tau)^m(1 - \phi\tau)^n\exp\left[-\beta\frac{1 - \tau}{1 - \alpha(1 - \tau)}\right]
\]
5. **Matching condition**:
\[
\beta^{m + n+1/2}\Lambda\phi^n=\int_0^{\infty}t^m(t + \gamma_l)^n e^{-t}dt\equiv G(m, n, \gamma_l)
\]
where \(\gamma_l=\beta\frac{1 - \phi}{\phi}\).
### Conclusions
- **Influence of the Arrhenius factor**: The research shows that the influence of the Arrhenius factor in the prediction of the burning velocity is not always dominant. Even in the absence of differential diffusion, the maximum burning velocity may occur under non - stoichiometric conditions.
- **Applicability for different fuels**: For some hydrocarbon - air mixtures (such as ethylene - air), the one - step Arrhenius chemical approximation can provide a reasonable fit for the burning velocity data. But for methane - air mixtures, this approximation is not accurate enough.
- **Adjustment of the reaction order**: By adjusting the reaction orders \(m\) and \(n\)