Electromagnetic design study of a superconducting longitudinal gradient bend magnet based on the HALF storage ring
Chao Chen,Lin Wang,Guangyao Feng,Weimin Li,Penghui Yang
DOI: https://doi.org/10.1088/1748-0221/18/06/P06003
2023-01-01
Journal of Instrumentation
Abstract:The National Synchrotron Radiation Laboratory is planning to build a 2.2 GeV diffraction-limited storage ring, the Hefei Advanced Light Facility (HALF), with a 6BA lattice structure and a large number of longitudinal gradient bends (LGBs). In order to increase the radiated photon energy to the hard X-ray band and to reduce the natural emittance, a superconducting longitudinal gradient bend (SLGB) magnet is planned to be used on HALF in the future, which requires a magnetic field integral of 0.40 T center dot m over a length of 0.46 m and a peak field of about 5 T. A SLGB has many structural parameters, such as the geometric parameters of the superconducting coils and the thickness of the yoke, etc. Their influence on the magnetic field distribution has been studied, although the computation of the 3D magnet model is very slow. Considering the longitudinal field variation, the vertical gap limitation, the field homogeneity requirement and the critical current of the superconducting wire, a method is developed to simplify the 3D magnet simulation by a corresponding 2D model, so that the longitudinal magnetic field profile of a 3D model can be approximately calculated in a 2D model with faster speed. Due to the faster calculation speed of 2D models, a Mathematica-based optimization program is developed and relatively good structural parameters for the HALF SLGB are found by the program. The simulation results show that the physical design requirements can be well met. The electromagnetic design for the HALF SLGB magnet is based on the current ???? level of NbTi superconductor due to its excellent mechanical performance.