Abstract:This work presents the design and evaluation of a fully wireless, multi-point temperature sensor system as a Process Analytical Technology (PAT) for lyophilization. Each sensor contains seven sensing elements which measure the product temperature at various positions of the contents of a glass vial. The sensor performance was studied by freeze drying experiments with sensor placement in both center and edge of full shelf of 6R glass vials with 4 ml fill volume. Product temperature profile and primary drying time measured at the bottom center position in the glass vial by the wireless sensor as well as the primary drying time are in close comparison with the thermocouple data. The drying times during primary drying were determined at the top, higher middle, lower middle and bottom positions which are 3.26 mm apart vertically in the vial by the wireless sensor based on the temperature profile measured at different positions. For a center vial, the drying time from the start of primary drying to each layer was measured at 3.9, 9.3, 14.2, and 21 h respectively, allowing to track the sublimation interface during primary drying phase. In addition, sublimation rate at each layer was calculated based on the drying time and theoretical weight loss of ice in the product. The sublimation rate at the beginning of the primary drying was similar to the sublimation rate by gravimetric method. Furthermore, the vial heat transfer coefficient (Kv) was also calculated based on the sublimation rate. Thus, allowing the use of the multi-point wireless sensor to rapidly monitor the sublimation rate and Kv for every batch as continuous process verification. Similar tests were also conducted with 3% w/v mannitol solutions and the results were consistent demonstrating potential for real-time monitoring, process verification and cycle optimization for pharmaceutical lyophilization.

An accurate detection of micro-collapse during the lyophilisation of a 5% w/v lactose solution using a combination of novel techniques: intelligent laser speckle imaging (ILSI) and through-vial impedance spectroscopy (TVIS)

Observations on the Changing Shape of the Ice Mass and the Determination of the Sublimation End Point in Freeze-Drying: An Application for Through-Vial Impedance Spectroscopy (TVIS)

Development of a Single Vial Mass Flow Rate Monitor to Assess Pharmaceutical Freeze Drying Heterogeneity

Monitoring Aqueous Sucrose Solutions Using Droplet Microfluidics: Ice Nucleation, Growth, Glass Transition, and Melting

Multi-Point Wireless Temperature Sensing System for Monitoring Pharmaceutical Lyophilization

Thermal stabilization of biologics inside glass vials using light-assisted drying (LAD)

A Simple and Cost-Effective Technique to Monitor the Sublimation Flow During Primary Drying of Freeze-Drying Using Shelf Inlet/Outlet Temperature Difference or Chamber to Condenser Pressure Drop

Comparison of Tunable Diode Laser Absorption Spectroscopy and Isothermal Micro-calorimetry for Non-invasive Detection of Microbial Growth in Media Fills

Leakage Detection of Vial Based on Tunable Diode Laser Absorption Spectroscopy

Surface Treatment of Glass Vials for Lyophilization: Implications for Vacuum-Induced Surface Freezing

Automated Tomographic Assessment of Structural Defects of Freeze-Dried Pharmaceuticals

Finite Element Method (FEM) Modeling of Freeze-drying: Monitoring Pharmaceutical Product Robustness During Lyophilization

Infrared Thermography for Monitoring of Freeze Drying Processes-Part 2: Monitoring of Temperature on the Surface and Vertically in Cuvettes during Freeze Drying of a Pharmaceutical Formulation

A Novel MATLAB®-Algorithm-Based Video Analysis to Quantitatively Determine Solution Creeping in Intact Pharmaceutical Glass Vials

Automatic control of a freeze-drying process: Detection of the end point of primary drying

Freeze-drying-induced mutarotation of lactose detected by Raman spectroscopy

Quantifying Crystalline Α-Lactose Monohydrate in Amorphous Lactose Using Terahertz Time Domain Spectroscopy and Near Infrared Spectroscopy

Model-Based Optimisation and Control Strategy for the Primary Drying Phase of a Lyophilisation Process

Microcrystallization of lactose during droplet drying and its effect on the property of the dried particle