Kinetic and geometric considerations in modeling screen-printed electrode-based sensors
Ashley Kuhnley,Suzanne Fisher,John Valdovinos
DOI: https://doi.org/10.1007/s10800-023-02058-9
IF: 2.925
2024-02-06
Journal of Applied Electrochemistry
Abstract:Numerical models of electrochemical sensors using screen-printed electrodes (SPEs) are limited. Simulating the dynamic response of SPEs is challenging due to their complex geometry and kinetic behavior. In this paper, we present a general process by which SPEs can be modeled using commercial finite element software, COMSOL Multiphysics. Parameters such as electroactive surface area and the heterogenous rate constant were derived empirically using a commonly used redox couple of hexaammineruthenium (III), , and hexaammineruthenium (II), . Experimentally derived parameters were used in the model and a transient numerical simulation was run to replicate the cyclic voltagramms procured from experiment. The results show that the electroactive area was measured to be 2.3 (± 0.674), which was less than the 3.14 geometric area. In addition, the heterogeneous kinetic constant at various voltage scanning rates, ranging from 25 to 500 mV/s, were measured. Uncompensated resistance was measured as 301.9 (± 1.6) and was also incorporated as a parameters in the model. Numerical results as represented by voltagramms shapes were consistent with experimental results. The model was able to predict the maximum anodic current density with an accuracy of 30.5%, 22.9%, 13.4%, 16.2%, 12.8%, 14.8%, and 14.6% for scan rates ranging from 25 to 500 mV/s (25, 50, 75, 100, 200, 300, 400, and 500 mV/s, respectively). The model was more accurate in predicting maximum cathodic currents with accuracy values of 1.7%, 1.2%, 5.5%, 4.1%, 1.7%, 2.4%, and 2.2% for scan rates ranging from 25 to 500 mV/s. The results demonstrate the first attempt to model the SPEs which incorporate experimentally derived parameters. These types of models are expected to help biosensor researchers simulate sensor response before fabrication and testing.
electrochemistry