Design and Analysis of a Detuned Series-Series IPT System with Solenoid Coil Structure for Drone Charging Applications

Elias Nadi,Hua Zhang

2024-05-21

Abstract:This paper proposes a new coil configuration that uses solenoid ferrites on the receiver side instead of planar ferrite coils that are employed in existing wireless charging systems.The solenoid ferrites are used in the drone legs to help mount the receiver on a moving truck while the two parts of the transmitter are placed on the

Systems and Control

What problem does this paper attempt to address?

This paper proposes a novel coil structure for drone charging - the self-biased series-series (SS) inductive power transfer (IPT) system, which specifically uses spiral coil ferrite instead of planar coil ferrite. The purpose of the study is to address the issues of over-power and over-current that may occur in wireless charging systems when the magnetic coupling is weak or zero, as well as to improve tolerance to misalignment.

In the traditional SS IPT system, high current may occur when the magnetic coupling is poor, leading to system damage. To solve this problem, the paper proposes a biased design that restricts the system's output power and transmission side current even under zero coupling conditions. Experimental results show that the system operates at a switching frequency of 245 kHz and has a primary side resonance frequency of 223.5 kHz, which is a biased design. Under zero coupling conditions, the transmission current is limited to 4.5 A with a power loss of only 4.2 W. The system targets a power of 50 W, with an air gap of 10 mm and a horizontal and vertical misalignment range of 0 to 50 mm. Through experimental verification, the system is capable of charging an 11.1V battery at a power of 48.2W with an efficiency of 88.2%.

The paper also describes a new magnetic coupler design using a spiral coil structure, with a cylindrical ferrite on the transmitter side and a spiral coil ferrite on the receiver side, which improves tolerance to misalignment. In addition, the system employs a battery management system (BMS) to control and stabilize the output voltage, preventing overvoltage damage to the battery.

Experimental results demonstrate that the system operates normally without load, with an output power of 48.2 W under good alignment conditions. Under conditions of 50 mm Y-axis misalignment and 10 mm X-axis misalignment, the output power can reach 67.93 W, and zero voltage switching (ZVS) is achieved in both cases.