Energy Recovery System for Large Telescopes

Aleksej Kiselev,Matthias Reichert,Tony Mroczkowski

2024-06-20

Abstract:In this paper, a kinetic energy recovery system for large telescopes is presented, with the Atacama Large Aperture Submm Telescope (AtLAST) as a possible target application. The system consists of supercapacitors integrated in the DC-link of motor inverters through a bidirectional DC-DC converter. The optimal system design, based on the energy flow analysis within the telescope's power electronics, is introduced. The proposed system is simulated as part of the telescope's drives, providing not only a significant reduction in energy consumption of the telescope due to motion, but also remarkably reducing (or shaving) grid power peaks. We find that the system presented here can contribute to making both current and future observatories more sustainable.

Instrumentation and Methods for Astrophysics

What problem does this paper attempt to address?

This paper attempts to solve the problems of high energy consumption and high peak - power demand from the power grid during the movement of large telescopes. Specifically, the author proposes a kinetic - energy recovery system, aiming to significantly reduce the energy consumption of telescope movement and effectively cut down the peak - power demand of the power grid by storing and reusing the electrical energy generated when the telescope decelerates.

### Problem Background

Large telescopes (such as the Atacama Large Aperture Submm Telescope, AtLAST) have a huge structural mass and need to accelerate and decelerate frequently and rapidly. These telescopes are usually located far away from the power grid, so energy management and efficiency are particularly important. Especially in the high - frequency scanning mode, the motors of the telescopes generate a large amount of electrical energy when decelerating, but this energy is usually wasted as heat through the braking resistors.

### Solution

To solve this problem, the paper proposes a kinetic - energy recovery system based on supercapacitors and bidirectional DC - DC converters. The working principle of this system is as follows:

1. **Supercapacitors**: Used to store the electrical energy generated during deceleration.
2. **Bidirectional DC - DC converters**: Connect the DC link between the supercapacitors and the motor inverters to achieve precise control of the charging and discharging processes of the supercapacitors.

### Main Contributions

- **Improving Energy Efficiency**: By reusing the energy generated during deceleration, the overall energy consumption of telescope movement is reduced.
- **Reducing Peak - power of the Power Grid**: By storing energy in supercapacitors and releasing it when needed, instantaneous high - power demands are avoided, thus reducing the peak load of the power grid.
- **Sustainability**: This system helps to make current and future observatories more environmentally friendly and cost - effective, especially for telescopes that are completely dependent on renewable energy for power supply, such as AtLAST.

### Application Scenarios

This system is not only applicable to AtLAST, but also suitable for other large telescopes that need to accelerate and decelerate frequently, such as Vera Rubin Observatory, Simons Observatory and CMB - S4, etc. In addition, the concept of this system can be extended to more facilities within the electromagnetic spectrum range.

### Summary

By introducing this kinetic - energy recovery system, the paper shows how to significantly improve the energy efficiency of large telescopes while reducing the demand for power grid infrastructure, thus promoting the development of astronomical observation equipment in a more sustainable direction.