Abstract:This paper presents a comparison between two design methodologies applied to permanent magnet synchronous machines for hybrid and electric vehicles (HEVs and EVs). Both methodologies are based on 2D finite element models and coupled to a genetic algorithm to optimize complex non-linear geometries such as multi-layer permanent magnet machines. To reduce the computation duration to evaluate Induced Voltage and Iron Losses for a given electrical machine configuration, a new methodology based on geometrical symmetries and magnetic symmetries are used and is detailed. Two electromagnetic models have been developed and used in the design stage. The first model was the stepped rotor position finite element analysis called abc model which considered the spatial harmonics without any approximation of the waveform of flux linkage inside the stator, and the second model was based on a fixed rotor position called dq model, with the approximation that the waveform of flux linkage inside the stator was sinuous. These two methodologies are applied to the design of a synchronous machine for HEVs and EVs applications. Design results and performances are analyzed, and the advantages and drawbacks of each methodology are presented. It was found that the dq model is at least 5 times faster than the abc model with high precision for both the torque and induce voltage evaluation in most cases. However, it is not the case for the iron losses computation. The iron loss model based on dq model is less accurate than the abc model with a relative deviation from the abc model greater than 70% at high control angle. The choice of the electromagnetic model during the optimization process will therefore influence the geometry and the performances of the obtained electrical machine after the optimization.

Multi-material topology optimization of an electric machine considering demagnetization

Analysis and Suppression of Cross-Coupling Demagnetization in Dual Permanent Magnet Machine for Direct-Drive Application

Comparison of Dual-Stator Permanent Magnet Machines with Different Rotor Topologies

Multi-Material Topology Optimization with Continuous Magnetization Direction for Permanent Magnet Synchronous Reluctance Motors

A Nonlinear 3-D Hybrid Model for Surface-Mounted Permanent Magnet Machines Considering End Effect

A Novel Dual Permanent Magnet Fault-Tolerant Vernier Machine with Hybrid Stator Configuration

Novel multi-material topology optimization method for multi-segmented permanent magnet motors

A Multimaterial Topology Optimization Considering the PM Nonlinearity

A Novel Derivative Free Methodology for Multi-Material Topology Optimization Based on Projective Transformations and Boolean Operations

A Manufacturing Oriented Topology Optimization Methodology for Permanent Magnet Synchronous Motor

Variance-based Robust Optimization of a Permanent Magnet Synchronous Machine

A Multi-Objective Topology Optimization Methodology and Its Application to Electromagnetic Actuator Designs

Nonlinear Analytical Model-Embedded Optimal Design for ER-PMSM

Global Magnetic Topology Optimization

Design Optimization of Multi-Layer Permanent Magnet Synchronous Machines for Electric Vehicle Applications

Topology Optimization of Electric Machines based on Topological Sensitivity Analysis

A Multi-Objective Topology Optimization Methodology Using Deep Learning and Its Application to Electromagnetic Devices

Multi-Objective Optimization of Electrical Machines using a Hybrid Data-and Physics-Driven Approach

Multi-Objective Optimization Design and Analysis of V-Shape Permanent Magnet Synchronous Motor

Solid Isotropic Material with Penalization-Based Topology Optimization of Three-Dimensional Magnetic Circuits with Mechanical Constraints

Design and Analysis of a Novel High-Speed Permanent Magnet Machine with Dual Semi-Cage Winding