Abstract:We explore the possibility of simulating the grade-two fluid model in a geometry related to a contraction rheometer, and we provide details on several key aspects of the computation. We show how the results can be used to determine the viscosity $\nu$ from experimental data. We also explore the identifiability of the grade-two parameters $\alpha_1$ and $\alpha_2$ from experimental data. In particular, as the flow rate varies, force data appears to be nearly the same for certain distinct pairs of values $\alpha_1$ and $\alpha_2$; however we determine a regime for $\alpha_1$ and $\alpha_2$ for which the parameters may be identifiable with a contraction rheometer.

What problem does this paper attempt to address?

The problem that this paper attempts to solve is: **How to simulate and identify the parameters of the grade - two fluid model through the contraction rheometer?** Specifically, the authors explored the possibility of simulating the grade - two fluid model in the geometry related to the contraction rheometer and introduced several key aspects in the calculation in detail. They showed how to determine the viscosity $ \nu $ from the experimental data and studied the possibility of identifying the grade - two fluid model parameters $ \alpha_1 $ and $ \alpha_2 $ from the experimental data. In particular, when the flow rate changes, the force data for some different pairs of $ \alpha_1 $ and $ \alpha_2 $ are almost the same; however, they determined a parameter range within which the contraction rheometer can be used to identify these parameters. ### Main problem decomposition: 1. **Simulating the grade - two fluid model**: - The researchers explored the methods of simulating the grade - two fluid model in the geometry of the contraction rheometer. - Specific methods for numerically solving the model equations were provided, including new algorithms and implementations that support general parameters and inflow boundary conditions. 2. **Parameter identification**: - By analyzing the force integral data under different parameter combinations, the researchers attempted to find a parameter range so that $ \alpha_1 $ and $ \alpha_2 $ can be uniquely determined from the experimental data. - Special attention was paid to the phenomenon that the force data of some parameter pairs are almost the same when the flow rate changes, and attempts were made to find the conditions that can distinguish these parameters. 3. **Viscosity determination**: - It was shown how to determine the viscosity $ \nu $ from the experimental data, which is an important step in the rheometer's measurement of fluid properties. ### Mathematical model: The basic equations of the grade - two fluid model are: \[ -\nu \Delta u + u \cdot \nabla u + \nabla p = \nabla \cdot \mathbf{\tau}, \quad \nabla \cdot u = 0 \text{ in } \Omega, \quad u = g \text{ on } \partial \Omega \] where, \[ \mathbf{\tau} = \alpha_1 \left( u \cdot \nabla A - A \circ (\nabla u)^T - (\nabla u) \circ A \right)+(2\alpha_1 + \alpha_2) A \circ A \] and $ A=\nabla u + (\nabla u)^T $. ### Experimental design: - Experiments were carried out using the contraction rheometer by changing the flow rate and measuring the corresponding force data. - Force integrals were calculated through numerical simulation to analyze the results under different parameter combinations. ### Conclusion: The main conclusion of the research is that although the force data are difficult to distinguish under certain parameter combinations, within a specific parameter range, the contraction rheometer can be used to identify the parameters $ \alpha_1 $ and $ \alpha_2 $ of the grade - two fluid model. This provides theoretical basis and technical support for future research.

Computational analysis of a contraction rheometer for the grade-two fluid model

Analytical Method of Nonlinear Coupled Constitutive Relations for Rarefied Non-Equilibrium Flows

Numerical Simulation of Gases over Flat Plate Using Two-Temperature Nonlinear Coupled Constitutive Relations

Analysis of Gas Flow over a Cylinder at All Knudsen Numbers Based on Non-Newtonian Constitutive Models

Numerical Investigation on Local Non-equilibrium Flows Using a Diatomic Nonlinear Constitutive Model

Some Considerations on the Rheology of Dense Frictional Cylindrical Particles

Further validation to the variational method to obtain flow relations for generalized Newtonian fluids

Computing orientation distribution and rheology of turbulent fiber suspensions flowing through a contraction

Comparative study of Eyring–Powell fluid flow with temperature-dependent viscosity in roll-rotating systems: An analytic, numeric, and machine learning approach

The rheological kolmogorov scales of viscoelastic Oldroyd-B fluids

Newtonian fluid dynamics in a misaligned parallel-plate rheometer

Scaling Description of Frictionless Dense Suspensions under Inhomogeneous Flow

Scientific Machine Learning for Modeling and Simulating Complex Fluids

Flow rate-pressure drop relations for shear-thinning fluids in deformable configurations: theory and experiments

Technical computations for dependent shear rate effect on magnetized peristaltic transport of synovia with two fluid viscosity models: Arthritis treatments

Modal logics with the Macintosh rule

Simulation-based High-Speed Elongational Rheometer for Carreau-type Materials

Two-fluid modeling of heat transfer in flows of dense suspensions

On Modeling the Response of Synovial Fluid: Unsteady Flow of a Shear-Thinning, Chemically-Reacting Fluid Mixture

Numerical Simulations of the Flow of a Dense Suspension Exhibiting Yield-Stress and Shear-Thinning Effects