Optimized Masking for MIMO Radar Signals
Shenghua Zhou,Yifan Zhang,Hui Ma,Xiaojun Peng,Dongfang Yang,Hongwei Liu,Junkun Yan
DOI: https://doi.org/10.1109/taes.2021.3082713
IF: 3.491
2021-10-01
IEEE Transactions on Aerospace and Electronic Systems
Abstract:Electronic attack devices can interrupt a radar system by emitting jamming signals. This function typically depends on the support from electronic support measure (ESM) devices, which can capture and identify radar signals in the air. A radar system can avoid being interrupted by confusing adversarial ESM devices. In this article, at the background of colocated multiple-input multiple-output radar, we present an active antijamming method that aims at confusing adversarial ESM devices by masking radar signals with accompanying signals. Masking signals can be transmitted in either the pulsed mode or the periodic continuous-waveform mode. They can be either constant-modulus or with amplitude modulation. The masking signal will cover the radar signal in both time and frequency domains, in order to make adversarial ESM devices find it hard to determine whether an intercepted signal source is a spoofing device or an operating radar. We suppress the impact of masking signals on radar-matched filters, measured by the integrated sidelobe level and peak sidelobe level of their cross-correlation sidelobes, through optimization of masking signals. Masking signals whose chip duration is shorter than that of radar signals are considered for a lower cross-correlation sidelobe level. It is termed as the sequence spread spectrum method, and this method is found critical to obtain good cross-correlation sidelobes, as indicated in numerical results with several kinds of well-designed radar signals. In concerned simulation scenarios, a good masking signal tends to focus its power on frequency bands, where the radar signal power is low.
telecommunications,engineering, electrical & electronic, aerospace