Abstract:The large extensional viscosity of dilute polymer solutions has been shown to dramatically delay the breakup of jets into drops. For low shear viscosity solutions, the jet breakup is initially governed by a balance of inertial and capillary stresses before transitioning to a balance of viscoelastic and capillary stresses at later times. This transition occurs at a critical time when the radius decay dynamics shift from a 2/3 power law to an exponential decay as the increasing deformation rate imposed on the fluid filament results in large molecular deformations and rapid crossover into the elasto-capillary regime. By experimental fits of the elasto-capillary thinning diameter data, a relaxation time of less than 100 μs has been successfully measured. In this paper, we show that, with a better understanding of the transition from the inertia-capillary to the elasto-capillary breakup regime, relaxation times close to 10 μs can be measured with the relaxation time resolution limited only by the frame rate and spatial resolution of the high speed camera. In this paper, the dynamics of drop formation and pinch-off are presented using dripping onto substrate capillary breakup extensional rheometry (CaBER-DoS) for a series of dilute solutions of polyethylene oxide (PEO) in water and in a viscosified water and glycerin mixture. Four different molecular weights between 100 k and 1 M g/mol were studied with varying solution viscosities between 1 and 22 mPa s and at concentrations between 0.004 and 0.5 times the overlap concentration, c*. The dependence of the relaxation time and extensional viscosity on these varying parameters was studied and compared to the predictions of dilute solution theory while simultaneously searching for the lower limit in solution elasticity that can be detected. For PEO in water, this limit was found to be a fluid with a relaxation time of roughly 20 μs. These results confirm that CaBER-DoS can be a powerful technique characterizing the rheology of a notoriously difficult material to quantify, namely, low viscosity inkjet printer inks.

Elasticity affects the shock-induced aerobreakup of a polymeric droplet

Elasticity affects the shock-induced aerobreakup of a polymeric droplet

Aerodynamic bag breakup of a polymeric droplet

Elasticity can affect droplet coalescence

A Comparative Study on the Breakup of Newtonian and Viscoelastic Liquid Films

Suppressed Leidenfrost phenomenon during impact of elastic fluid droplets

Viscoelastic Worthington jets \& droplets produced by bursting bubbles

Flows Inside Polymer Microfluidic Droplets: Role of Elasticity

Experimental dynamics of Newtonian non-elastic and viscoelastic droplets impacting immiscible liquid surface

Breakup Dynamics of Elastic Droplet and Stretching of Polymeric Filament in a T-junction

Bursting bubble in an elasto-viscoplastic medium

Experimental Investigation on the Properties of Liquid Film Breakup Induced by Shock Waves

Single and two-phase fluid droplet breakup in impulsively generated high-speed flow

Bursting bubble in an elastoviscoplastic medium

Drop breakup dynamics of dilute polymer solutions: Effect of molecular weight, concentration, and viscosity

On viscoelastic drop impact onto thin films: axisymmetric simulations and experimental analysis

Dynamics of impact of polymer droplets on viscoelastic surfaces

Coalescence of bubbles in a viscoelastic liquid

Viscoelastic vapor bubble collapse near solid walls and corresponding shock wave formation

Droplet deformation and breakup in shear-thinning viscoelastic fluid under simple shear flow

Formation Dynamics of Elastic Droplets in a Microfluidic T-junction