Abstract:This work reports a comprehensive multiphysics modeling and optimization of a MEMS-based piezoelectric inertial measurement unit (IMU) sensor using a single proof mass. The studied miniaturized sensor consists of a stick-shaped cylindrical proof mass with two concentric rings connected between them with joints where the stress is concentrated. The advantage of introducing this new piezoelectric IMU concept is the concurrent detection of all six degrees of freedom (DOFs), i.e., 3-axis linear accelerations and angular velocities, using a single seismic mass and only four electrodes. The piezoelectric IMU structure optimization was carried out using finite element analysis (FEA) in order to obtain the optimal dimensions and generate the maximum stress in the piezoelectric layer. In fact, the mechanical (displacement and stress) and electrical (potential and sensitivity) performance of the IMU structure was determined when 3-axis linear accelerations and 3-axis angular velocities were applied. The simulation results showed a sensitivity of 1 mV/g and 6.8 mV/g, respectively, for linear accelerations along the x-/y- and z-axes. Along these same axes, the angular velocity sensitivity was approximately 0.39 μV/rad/s and 1.7 mV/rad/s. Moreover, the simulation results claim that the proposed IMU has good performance in terms of cross-axis sensitivity of less than 0.88% for all six DOFs, which is due to its perfectly symmetric circular structure. Finally, a simple block diagram is presented to separate the outputs related to linear acceleration from those related to angular velocity from the four sensing electrodes.

Sensitivity and Bandwidth of a Point-Source-Interferometry-based Inertial Measurement Unit Employing Large Momentum Transfer and Launched Atoms

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

A Continuous Dual-Axis Atomic Interferometric Inertial Sensor

Toward High-Resolution Inertial Sensors Employing Parametric Modulation in Coupled Micromechanical Resonators

Multi-axis inertial sensing with 2D arrays of matter waves

Gyro-Free Inertial Measurement Unit with Unfettered Accelerometer Array Distribution and for the Object with Position Change in Center of Gravity

Parametrically driven inertial sensing in chip-scale optomechanical cavities at the thermodynamical limits with extended dynamic range

Experiment System Design of Non-Gyro Inertial Measurement Unit

MEMS strapdown inertial attitude measurement system using rotational modulation technology

Multiaxis atom interferometry with a single diode laser and a pyramidal magneto-optical trap

Attitude Measurement for High-Spinning Projectile with a Hollow MEMS IMU Consisting of Multiple Accelerometers and Gyros

Improved multi-position calibration for inertial measurement units

A Multi-Position Calibration Algorithm for Inertial Measurement Units

Closed-Loop Dual-Atom-Interferometer Inertial Sensor with Continuous Cold Atomic Beams

Design of a nine-accelerometer non-gyro inertial measurement unit

Research On Angular Velocity Of Non-Gyro Inertial Measurement Unit

Initial Calibration of MEMS Inertial Measurement Unit

A comprehensive modeling of a 6-axis single proof mass MEMS-based piezoelectric IMU

Atom interferometry at arbitrary orientations and rotation rates

Method for measuring non-stationary motion attitude based on MEMS-IMU array data fusion and adaptive filtering

A Vibration Sensing Device Using a Six-Axis IMU and an Optimized Beam Structure for Activity Monitoring