Abstract:Abstract Components with internal passages created using some laser-sintering based, additive manufacturing (AM) systems can exhibit anisotropic surface features with an appearance of three-dimensional roughness superimposed on two-dimensional, rib-like features. This paper presents an investigation of flow over roughness representing internal cooling passages printed at different angles to the AM printing plane. A roughness geometry was acquired using an X-ray tomography scan of a direct-metal-laser-sintering (DMLS) created coupon with internal cooling passages. The base surface scan was then used to create four surfaces with notional rib-like features positioned at different angles relative to the spanwise flow direction. The flow resistance of each surface was measured using the roughness internal flow tunnel. The mean flow velocity profiles for the cases with ReDh ≤ 30,000 were characterized using a four-camera, tomographic, and particle tracking system. The results demonstrate roughness orientation effects include (1) reduced bulk flow resistance as the alignment angle from the spanwise direction increases, (2) generated flow in the spanwise direction and increased tunnel flow swirl as the alignment angle increases, and (3) velocity profile changes as the flow migrates away from the rough side of the tunnel to the opposing smooth wall. The particle tracking system also demonstrates that the mean streamwise flow profiles change significantly between the 30 deg and 45 deg roughness orientations. Finally, the equivalent sandgrain roughness measurements for the four surfaces were found to follow the trends predicted using the correlations of Bons (2002, “St and cf Augmentation for Real Turbine Roughness With Elevated Freestream Turbulence,” ASME J. Turbomach., 124(4), pp. 632–644.) and Sigal and Danberg (1990, “New Correlation of Roughness Density Effect on the Turbulent Boundary Layer,” AIAA J., 28(3), pp. 554–556.).

A Synthetic Modal Generation of Additive Manufacturing Roughness Surfaces from Images

Computing Variation Modes for Point Set Surfaces.

Computer Simulation of Rough Surfaces

Synthesis of engineering surfaces using representative elementary patterns of roughness

A virtual stylus method for non-destructive roughness profile measurement of additive manufactured lattice structures

Data-driven and Automatic Surface Texture Analysis Using Persistent Homology

Surface texture measurement for additive manufacturing

Monte Carlo Simulation Study of Scanning Electron Microscopy Images of Rough Surfaces

Flow Through a Passage With Scaled Additive Manufacturing Roughness Representing Different Printing Orientations

Characterization and assessment of surface roughness using novel data representation methods

A Simulation Method for Non-Gaussian Rough Surfaces Using Fast Fourier Transform and Translation Process Theory

Preprocessing method for robust topography reconstruction of surfaces of metal additive manufactured parts based on focus variation microscopy

Stochastic additive manufacturing simulation: from experiment to surface roughness and porosity prediction

Efficient modelling of surface roughness effects in additively manufactured materials

Realistic Pattern Formations on Surfaces by Adding Arbitrary Roughness

Stochastic Geometry Models for Texture Synthesis of Machined Metallic Surfaces: Sandblasting and Milling

Non-Contact Surface Roughness Measurement by Implementation of a Spatial Light Modulator

Theoretical modelling and prediction of surface roughness for hybrid additive–subtractive manufacturing processes

Model of rough surfaces with Gaussian processes

Fractal Characterisation of Inhomogeneous Rough Surfaces

Simulation of Optical Surfaces and Their Psd Study