Abstract:Coexisting ammonium (NH4+-N) and phosphate (PO43--P) in wastewater is one of the main causes of eutrophication, which poses severe risks to aquatic ecosystem and human health worldwide. Herein, magnesium-rich tricalcium aluminate (Mg/C3A), which was constructed by incorporating Mg into cement-based material C3A via solid-state reaction, was employed in the simultaneous removal of NH4+-N and PO43--P. Considering the wastewater with unbalanced N/P ratio and fluctuant pH, the effect of multiple factors (Mg/C3A dosage, pH, initial contaminant concentration, and temperature) on the removal of both ions were systematically investigated by employing response surface methodology technique. The results demonstrated that the impact order of the factors on the NH4+ removal by Mg/C3A was: temperature > Mg/C3A dosage > initial NH4+ concentration > pH > initial PO43− concentration; the impact order on the PO43− removal was: initial PO43− concentration > Mg/C3A dosage > temperature > pH > initial NH4+ concentration. The maximum removal amount of NH4+ (54.13 mg g−1) and PO43− (56.47 mg g−1) were obtained at: Mg/C3A dosage = 3 g L−1, initial NH4+ concentration = 160 mg L−1, initial PO43− concentration = 160 mg L−1, temperature = 308 K, and pH = 7. In addition, the possible interactive influence mechanisms were elucidated in depth. Mg2+ played a major role in the PO43− removal by forming struvite (MgNH4PO4·6H2O) and newberyite (MgHPO4·3H2O). OH− released from Mg/C3A hydration mainly contributed to NH4+ removal. This work showed that Mg-rich C3A is a promising candidate for simultaneous removal of NH4+ and PO43−, shedding light on practical water remediation.

The simultaneous removal of calcium, magnesium and chloride ions from industrial wastewater using magnesium-aluminum oxide

The Performance and Mechanism of a Mg-Al Double-Layer Oxide in Chloride ion Removal from an Aqueous Solution

Research on the removal of Cr(VI) ions from wastewater by Mg/Al-layered double oxides

A novel magnesium-rich tricalcium aluminate for simultaneous removal of ammonium and phosphorus: Response surface methodology and mechanism investigation

Simultaneous removing algal and its extracellular organic matters by Mg/Al-layered double hydroxide /La-montmorillonite

Mixed Oxide Layered Double Hydroxide Materials: Synthesis, Characterization and Efficient Application for Mn2+ Removal from Synthetic Wastewater

Mg/Al LDH Enhances Sulfate removal and Clarification of AMD Wastewater in Precipitation Processes

Layered Double Hydroxides for Remediation of Industrial Wastewater from a Galvanic Plant

Simultaneous Removal of Arsenate and Fluoride Using Magnesium-Based Adsorbents

Removal of lead ions from wastewater using magnesium sulfide nanoparticles caged alginate microbeads

Sulfate removal from wastewater using ettringite precipitation: Magnesium ion inhibition and process optimization

Removal of the Colloidal Suspension from Dam Water Using Mineral Coagulants Prepared by Co-Precipitation

Efficient and fast arsenate removal from water by in-situ formed magnesium hydroxide

Chemical recovery of magnesium from the Dead Sea and its use in wastewater treatment

Fabrication of ultra-thin MgAl layered double oxide by cellulose templating and its immobilization effect toward heavy metal ions: cation-exchange and deposition mechanism

Preparation of MgX/Al 2 O 3 -Y sorbent for highly efficient simultaneous removal of hydrogen fluoride and hydrogen chloride under low-temperature environment

Efficient Removal of Eriochrome Black T (EBT) Dye and Chromium (Cr) by Hydrotalcite-Derived Mg-Ca-Al Mixed Metal Oxide Composite

Removal of Hg(II) with MgAl-layered double hydroxide functionalized by schiff base ligands: Application and condition optimization

Optimization of LDO-Pectin Synthesis Conditions for the Removal of Metals from Wastewater: A Comparison of Response Surface Methods and Taguchi Approaches

A novel method to remove chromium, vanadium and ammonium from vanadium industrial wastewater using a byproduct of magnesium-based wet flue gas desulfurization

Synthesis of Mg-Al Hydrotalcite Clay with High Adsorption Capacity