Abstract:Objectives: To evaluate the amount of apically extruded debris and to determine the remaining filling material on the root canal walls by microcomputed tomography (micro-CT), following the root canal retreatment of root canals filled with different obturation techniques (single cone technique, thermoplasticised injection technique) and the different root canal sealers [bioceramic-based, epoxy resin-based root canal sealer]. Materials and methods: 60 single rooted human premolar teeth were prepared with the ProTaper Gold system (Dentsply Maillefer) up to the F4 file and the samples were divided into 4 groups according to obturation procedures: Single cone technique + AH Plus sealer(epoxy resin-based root canal sealer, Dentsply International Inc., York, PA, USA); Single cone technique + Sure-Seal Root(bioceramic-based root canal sealer, Sure Dent Corporation, Gyeonggi-do, South Korea); thermoplastic injection technique[Calamus Dual Obturation System(Dentsply-Tulsa Dental, Tulsa, OK, USA)] + AH Plus(Dentsply International Inc.); Sure-Seal Root(Sure Dent Corporation) + Calamus Dual Obturation System (Dentsply-Tulsa Dental). The teeth were inserted into preweighed Eppendorf tubes and retreatment was performed. The tubes were kept in an incubator at 37 °C for 14 days to obtain the dry debris weight. Following the removal of the root canal fillings, the samples were scanned with a micro-CT device to analyse the volume of filling residues. Results: Retreatment of samples obturated with epoxy-resin or bioceramic based root sealers combined with Calamus system resulted in higher amount of apical extrusion compared to their combination with single cone technique (p = 0.026 for Single cone technique + AH Plus sealer vs Calamus + AH Plus sealer and p = 0.005 for Single cone technique + Sure-Seal root sealer vs Calamus + Sure-Seal root sealer). The most debris was observed in the Calamus + Sure-Seal root sealer group, the least debris was observed in the Single cone technique + AH Plus sealer group. The percentage of residues was the highest in the Single cone technique + Sure-Seal root sealer and the lowest in the Calamus + AH Plus sealer group, but there were no significant differences between groups (p = 0.463). Conclusions: No correlation was observed among the groups in terms of extruded debris and remnants inside the root canal. When combined with bioceramic based sealer, thermoplasticised injection technique did not affect the cleanliness of root canal walls; however, it increased its apical extrusion potential during retreatment. Clinical relevance: The obturation method does not play a role in the removability of bioceramic based root canal sealer, however the use of bioceramic-based root canal sealers with cold obturation techniques may be beneficial in preventing apical extrusion.

Ex vivo evaluation of artifacts mimicking fracture lines on cone-beam computed tomography produced by different root canal sealers

Quantitative Analysis of Cone-Beam Computed Tomography Artifacts Induced by Nonmetallic Root Canal Filling Materials Using Different Fields of View: In Vitro Study

Quantitative evaluation of artifact expression in conebeam computed tomography of mesoporous calcium silicate nanoparticles as a promising root canal sealer

Evaluation of artifacts produced by conventional dental materials in standard and high-resolution CBCT imaging

Quantitative Assessment of Dimensional Evaluation and Artefacts from Filling Materials with CBCT Using Standard Phantom Roots.

Comparative diagnostic yield of cone beam CT reconstruction using various software programs on the detection of vertical root fractures

Comparison sealing ability in three bioceramic sealers applied in hydraulic condensation technique by using micro-computed tomography

Comparative evaluation of root filling after obturation with gutta-percha and 3 different sealers of minimally instrumented root canals of the maxillary second molar

Evaluation of sealing ability of four bioceramic root canal sealers and an epoxy resin-based sealer: An in vivo study

Impact of CBCT acquisition protocols and artifact reduction filters on diagnosing vertical root fractures

Evaluation of the Sealing Ability and Bond Strength of Two Endodontic Root Canal Sealers: An In Vitro Study

Impact of root fillings and posts on the diagnostic ability of three intra-oral digital radiographic systems in detecting vertical root fractures

A micro-computed tomographic evaluation of root canal filling with a single gutta-percha cone and calcium silicate sealer

Influence of Artifacts Induced by Dental Implants on The Detection of Vertical Root Fractures in Cone Beam Computed Tomographic Scans. An in-Vitro Study

Optimization of Tube Current in Cone-beam Computed Tomography for the Detection of Vertical Root Fractures with Different Intracanal Materials

Effects of using different root canal sealers and protocols for cleaning intraradicular dentin on the bond strength of a composite resin used to reinforce weakened roots

Root canal cleanliness and debris extrusion following retreatment of thermoplastic injection technique and bioceramic-based root canal sealer

Residual Endodontic Filling Material after Post Space Preparation: A Confocal Microscopic Study

Field Emission Scanning Electron Microscope Analysis of the Marginal Adaptation of Various Root Canal Sealers at the Dentin-Sealer and Sealer-Guttapercha Interfaces at Three Root Canal Levels: An In Vitro Study

[Quantitative Assessment on Artifacts of Dental Restorative Materials in Cone Beam Computed Tomography].

Variable-resolution cone-beam computerized tomography with enhancement filtration compared with intraoral photostimulable phosphor radiography in detection of transverse root fractures in an in vitro model