Abstract:Carbon nanotubes (CNTs) are envisioned as ideal filaments for next-generation nanocomposites due to their high strength-to-weight ratios. However, while individual nanotubes are strong, interfaces between tubes cannot bear significant load due to the weak van der Waals forces that govern their behavior. Premature interfacial failure could thus counteract the inherent strength of carbon nanotubes and, in turn, prevent CNT-based composites from achieving optimal mechanical performance. To increase the load bearing capacity of these interfaces, interlayer crosslinking schemes have been proposed using chemical functionalization. For instance, introduction of hydrogen bonds or additional van der Waals bonds between tubes could improve load transfer between CNTs. While introducing chemical groups on CNT surfaces may enhance intermolecular interactions at these interfaces, a means of quantitatively evaluating changes in interlayer adhesion as a result of to these treatments needs to be defined. In addition, as sizes of CNTs will inherently vary within a composite, it is important that such energy measurements be normalized irrespective of tube dimensions. Here we report an experimental peeling technique that can be used to measure the adhesion energy between multiwalled carbon nanotubes (MWCNTs) and graphene. Peeling tests conducted in situ a scanning electron microscope allow direct visualization of the nanoscale peeling process which, in turn, enables adhesion energy to be estimated through classical fracture analysis. The applicability of this analysis is validated by finite element simulations with boundary conditions derived from experiments. The effective contact width between tubes and graphene is estimated via atomistic simulations, providing a means to normalize interaction energy per unit area. The surface energies of bare MWCNT-graphene interfaces found in this study compare favorably with theoretical and experimental values reported for graphite. This method can serve as a foundation for evaluating the enhancements afforded by chemical functionalization, which is a critical step toward the development of strong, lightweight composites that effectively utilize the full mechanical potential of CNTs.

Quantitative Measurement of adhesion energy between nanolayers and substrates using a nanowire-supported bridging method

Size-dependent Interface Adhesive Energy and Interface Strength of Nanostructured Systems

Numerical studies on deformation and adhesion behaviour of substrate during nanoindentation

The Adhesion of Mica Nanolayers on a Silicon Substrate in Air

Direct measurements of interfacial adhesion in 2D materials and van der Waals heterostructures in ambient air

Micromechanical Measurement of Active Sites on Silicon Nitride Using Surface Free Energy Variation

Precise Quantification of the Adhesion Between Metallic Thin Films and Silicon Wafer

Adhesion energy of single wall carbon nanotube loops on various substrates

An Easy Way to Quantify the Adhesion Energy of Nanostructured Cu/X (X = Cr, Ta, Mo, Nb, Zr) Multilayer Films Adherent to Polyimide Substrates

Determination of Adhesion Energy of CNx Thin Film on Silicon from Micro-Scratch Testing

In situ nanomechanical measurement of Cu nanowires

J212025 Fabrication of Nanowire Surface Fastener on Flexible Substrate and Its Electrical and Mechanical Properties

Molecular-Level Engineering of Adhesion in Carbon Nanomaterial Interfaces

Adhesion of 2D Materials: Measurement and Modulation

Analysis of Vibrational Dynamics in Cell-substrate Interactions Using Nanopipette Electrochemical Sensors

The Interfacial Adhesion of Contacting Pairs in Van Der Waals Materials

Assessing MWCNT-graphene Surface Energy Through in Situ SEM Peeling

Interfacial energy and strength of multiwalled-carbon-nanotube-based dry adhesive

Adhesion Energy of MoS2 Thin Films on Silicon-Based Substrates Determined Via the Attributes of a Single MoS2 Wrinkle.

Measurement of Interfacial Adhesion Force with a 3D-Printed Fiber-Tip Microforce Sensor

Wetting behavior of nanodroplets with low surface tension on pillar-type nanostructured substrates: Molecular dynamics simulations