Abstract:The use of pressurized bladders for stress control of superconducting magnets was firstly proposed at Lawrence Berkeley National Laboratory (LBNL) in the early 2000s. Since then, the so-called "bladders and keys" procedure has become one of the reference techniques for the assembly of high-field accelerator magnets and demonstrators. Exploiting the advantages of this method is today of critical importance for Nb3Sn-based accelerator magnets, whose production requires the preservation of tight stress targets in the superconducting coils to limit the effects of the strain sensitivity and brittleness of the conductor. The present manuscript reports on the results of an experimental campaign focused on the optimization of the "bladders and keys" assembly process in the MQXFB quadrupoles. These 7.2 m. long magnets shall be among the first Nb3Sn cryomagnets to be installed in a particle accelerator as a part of the High Luminosity upgrade of the LHC. One of the main practical implications of the bladders technique, especially important when applied to long magnets like MQXFB, is that to insert the loading keys, the opening of a certain clearance in the support structure is required. The procedure used so far for MQXF magnets involved an overstress in the coils during bladder inflation. The work presented here shows that such an overshoot can be eliminated thanks to additional bladders properly positioned in the structure. This optimized method was validated in a short model magnet and in a full-length mechanical model, becoming the new baseline for the series production at CERN. Furthermore, the results are supported by numerical predictions using Finite Element models.

Magnetic Measurements and Alignment Results of LQXFA/B Cold Mass Assemblies at Fermilab

Magnetic Measurements of HL-LHC AUP Cryo-Assemblies at Fermilab

Analysis of the mechanical performance of the 4.2 m long MQXFA magnets for the Hi-Lumi LHC Upgrade

MQXFA Final Design Report

First results of AUP Nb3Sn quadrupole horizontal tests

Quench Performance of the First Pre-series AUP Cryo-assembly

Application of Distributed Fiber Optic Strain Sensors to LMQXFA Cold Mass Welding

Verification Testing of MQXFA Nb3Sn Wires Procured Under LARP

Models and experimental results from the wide aperture Nb-Ti magnets for the LHC upgrade

A novel device for the measurement of the mechanical and magnetic axes of superconducting magnet assemblies for accelerators

Optimizing the use of pressurized bladders for the assembly of HL-LHC MQXFB magnets

Effect of CLIQ on training of HL-LHC quadrupole magnets

Performance of a MQXF Nb3Sn Quadrupole Magnet Under Different Stress Level

Design, Fabrication and Performance Test of SHINE Superconducting Quadrupole Magnets

Preliminary Study On Measurement Of Magnetic Center Of Quadrupoles Using Quadrupole Shunt For Hefei Storage Ring

Powering Tests Results of the First Batch of MCBXFB Magnets Produced in Industry

Design of the Magnets of the HALS Project

The Development of Magnetic Field Measurement System for Drift-Tube Linac Quadrupole

Mechanical Behavior of a 16-T FCC Dipole Magnet During a Quench

Development and Performance of RFD Crab Cavity Prototypes for HL-LHC AUP