Abstract:The fluctuating lift on a rectangular cylinder induced by turbulent flow is investigated by force measurement experiments. A square uniform grid is installed downstream of the entrance of the working section of the wind tunnel to generate approximately homogeneous and isotropic turbulence. The rectangular cylinder models of two different cross sections (width to depth ratio B/D = 5, 10) are tested in the experiments. Each rectangular cross section has two aspect ratios (length to width ratio θ = 1, 7) and a fixed width (B = 0.15 m). The measurements include the spectra of fluctuating lift force and vertical turbulent velocity component. From these measurements, the experimental values of generalized transfer functions of these rectangular cylinder models are obtained, which are compared with the calculated values based on three aerodynamic force theories. The one-wavenumber transfer functions and the spanwise influence terms of these rectangular cylinders are used in the calculations, which were determined by the pressure measurement experiments in the previous work. Comparisons of the measured and calculated values of generalized transfer functions demonstrate that the three-dimensional theory is satisfactory and confirm that the one-wavenumber transfer functions and spanwise influence terms determined by the pressure measurements are valid. The results also show that both the two-dimensional theory and the strip theory would overestimate the generalized transfer function, but for the rectangular cylinder with the larger aspect ratio, the strip theory is very close to the three-dimensional theory. The one-wavenumber transfer functions of these rectangular cylinders are therefore determined based on the strip theory. This indicates that the approximate approach to determination of the one-wavenumber transfer function, which was proposed for an airfoil in the previous work, could also be applicable to bluff bodies.

Unsteady loads on circular cylinder in cross-flow: an observation in natural wind and comparison with wind tunnel experiments

Les and Cdns Investigation of T106c Low Pressure Turbine

Twin Strouhal numbers in pressure loading of circular cylinder at high Reynolds numbers

Wind Loads on Fixed-Roof Cylindrical Tanks with Very Low Aspect Ratio

In wind tunnel the reproduction of vortex shedding behind circular cylinders at high Reynolds number regimes is incomplete

Measurements of fluctuating lift forces on rectangular cylinders in turbulent flow

Study of the wall pressure variations on the stall inception of a thick cambered profile at high Reynolds number

Field tests on a full-scale steel chimney subjected to vortex-induced vibrations

Aeroacoustics of a Square Finite-Wall-Mounted Cylinder in Pressure-Gradient Flows

Influence of Inflow Turbulence on the Flow Characteristics Around a Circular Cylinder

Base pressure fluctuations on levitated freestream-aligned circular cylinder

Experimental and numerical investigation of turbulent wake flow around wall-mounted square cylinder of aspect ratio 2

Experimental Investigation for Wind Pressure and Wind Load Factor of Tall and Special-Shaped Chimney

Streamline curvature effects generated by tornado-like flows on the aerodynamics of a low-rise structure

Effect of turbulent integral scale on non-Gaussian characteristics of surface wind pressure on square cylinder

Unsteady large-scale wake structure behind levitated freestream-aligned circular cylinder

On Interference Between Two Circular Cylinders in Staggered Arrangement at High Subcritical Reynolds Numbers

Wake Dynamics of Circular Finite Wall-mounted Cylinders in Different Boundary Layers

Wall-pressure fluctuations in an axisymmetric boundary layer under strong adverse pressure gradient

Wind Tunnel Simulation of Wind Loading on a Solid Structure of Revolution