Wake Dynamics of Circular Finite Wall-mounted Cylinders in Different Boundary Layers

R. Porteous,D. Moreau,Z. Prime,C. Doolan
Abstract:A circular finite wall-mounted cylinder (FWMC) in cross-flow is common in many engineering applications including commercial buildings, heat exchangers, aircraft landing gear and automobile appendages. The wake shedding dynamics of such objects depends primarily on the aspect ratio (ratio of length to diameter, L/D) and the height of the incoming boundary layer (δ). Unlike the aspect ratio, the effect of the height of the boundary layer on wake flow is poorly understood. This paper presents unsteady wake measurements obtained behind a circular FWMC with L/D= 18.2 in two different boundary layers with δ/L = 0.1 and 0.26, respectively. The results indicate that higher boundary layers alter the fluctuating characteristics of the wake at both the junction and free-end regions, even when the free-end lies significantly outside of the boundary layer itself. Introduction An FWMC is shown in Figure 1. The cylinder has one end immersed in the free stream (referred to as the ‘free-end’ or ‘tip’) and the other end fixed to a flat surface (referred to as the cylinder-wall ‘junction’) so that it is subject to a developing boundary layer of height δ. The cylinder is geometrically characterised by its span, L, and its diameter, D. The cylinder’s aspect ratio is defined as L/D.
Engineering,Physics
What problem does this paper attempt to address?