Abstract:Introduction. Functionally graded materials are of great use, because heterogeneity of properties enables to control the strength and rigidity of structures. This has caused great interest in the topic in the world scientific literature. The construction of solutions to such problems depends significantly on the type of boundary conditions. In this paper, we consider the equilibrium of a thin-walled circular cylinder whose mechanical properties change along the radius. Homogeneous boundary conditions were set on cylindrical surfaces that had not been considered before, the effect was on the ends. The mathematical formulation of the problem was carried out in the linear theory of elasticity in the framework of axisymmetric deformation. Expressions were constructed for the components of the stress-strain state of the cylinder, in which some coefficients were found from the solution to the resulting system of linear algebraic equations. Materials and Methods. The material of the cylinder was linearly elastic, the elastic modulus of which depended linearly on the radial coordinate. The basic research method was the asymptotic method, in which half the logarithm of the ratio of the outer and inner radii acted as a small parameter. Iterative processes were used to construct the characteristics of the stress-strain state of the cylinder. Results. Homogeneous solutions to the boundary value problem were obtained for a linearly elastic functionally gradient hollow thin-walled cylinder. An analysis of these solutions made it possible to reveal the nature of the stress-strain state in the cylinder wall. For this purpose, an asymptotic analysis of the solutions was carried out, relations for displacements and stresses were obtained. It was determined that those solutions corresponded to the boundary layer, while their first terms determined Saint-Venant edge effect similar to the plate theory. Discussion and Conclusion. The analytical solution to the equilibrium problem of a thin-walled cylinder inhomogeneous in radius constructed by asymptotic expansion can be used for numerical solution to a specific problem. For this, it is required to solve the obtained systems of linear algebraic equations and determine the corresponding coefficients. The resulting asymptotic representations provide analyzing the three-dimensional stress-strain state. The selection of the number of expansion terms makes it possible to calculate displacements and stresses with a given degree of accuracy. This analysis can be useful in assessing the adequacy of applied calculation methods used in engineering practice.

Complete set of bounds for the technical moduli in 3D anisotropic elasticity

Elastic bounds for anisotropic layers

The elastic stored energy of initially strained, or stressed, materials: restrictions and third-order expansions

A note on Cauchy-Voigt dispute of independent constants in anisotropic elastic Hooke's law

Preface -- Ares J. Rosakis

Hyperspace bounds on mixed mode elastic constants of n-component transversely-isotropic unidirectional materials

The Elastic Properties of Dilute Solid Suspensions with Imperfectly Bonded Inclusions of Ellipsoidal Shape: Bounds, Asymptotics, Approximations

On the isotropic moduli of 2D strain-gradient elasticity

Cauchy relations in linear elasticity: Algebraic and physics aspects

Thermodynamics of thermoviscoelastic solids of grade 3

Thermodynamic consistency of third grade finite strain elasticity

Theoretical elastic moduli for disordered packings of interconnected spheres

Large deformation isotropic elasticity – on the correlation of theory and experiment for incompressible rubberlike solids

PROBLEM OF THE ANISOTROPY OF ELASTICITY AND STRENGTH IN ANISOTROPIC FIBER MATERIALS

Symmetric stiffness matrices for isoparametric finite elements in nonlinear elasticity

On the elastic moduli of three-dimensional assemblies of spheres: characterization and modeling of fluctuations in the particle displacement and rotation

On Some Sufficient Conditions for Strong Ellipticity

Analysis of Stress-Strain State of a Cylinder with Variable Elasticity Moduli Based on Three-Dimensional Equations of Elasticity Theory

The gap in Pure Traction Problems between Linear Elasticity and Variational Limit of Finite Elasticity

Solution of a mixed nonaxisymmetric problem of the theory of elasticity for anisotropic bodies of revolution

A structurally frame-indifferent model for anisotropic visco-hyperelastic materials