Abstract:Bipolar thermoelectricity in tunnel junctions between superconductors of different energy gap has been recently predicted and experimentally demonstrated. This effect showed thermovoltages up to $\pm150\;\mu$V at milliKelvin temperatures. Thus, superconducting tunnel junctions can be exploited to realize a passive single-photon thermoelectric detector $TED$ operating in the broadband range 15 GHz - 50 PHz. In particular, this detector is expected to show a signal-to-noise ratio of about 15 down to $\nu=50$ GHz and a operating window of more than 4 decades. Therefore, the $TED$ might find applications in quantum computing, telecommunications, optoelectronics, spectroscopy and astro-particle physics.
What problem does this paper attempt to address?
The problem that this paper attempts to solve is to develop a passive single - photon thermoelectric detector (TED) that can operate in a wide frequency range (from 15 GHz to 50 PHz) to achieve efficient and highly sensitive single - photon detection. Specifically, the paper focuses on generating thermoelectric signals by using the spontaneous particle - hole symmetry breaking in superconducting tunnel junctions (STJs) and applying these phenomena to the design of single - photon detectors.
### Main problems and objectives of the paper
1. **Improve the performance of single - photon detectors**:
- Current superconducting single - photon detectors exhibit efficient energy resolution at frequencies below 1 THz, but the noise introduced by active readout signals and overheating can impair their performance.
- The paper proposes a passive single - photon thermoelectric detector (TED) aimed at overcoming these problems.
2. **Achieve single - photon detection in a wide frequency range**:
- This detector is expected to be able to operate in a wide frequency range, from 15 GHz to 50 PHz, with a relatively high signal - to - noise ratio (SNR), especially outstanding in the low - frequency band (such as 50 GHz).
3. **Application prospects**:
- This new type of detector may find wide applications in fields such as quantum computing, telecommunications, optoelectronics, spectroscopy, and astroparticle physics.
### Key points of the solution
- **Theoretical basis**: By studying the tunnel junctions between superconductors with different energy gaps, the bipolar thermoelectric effect has been discovered and verified. This effect can be achieved by the spontaneous particle - hole symmetry breaking.
- **Experimental verification**: Through the construction of a double - loop superconducting quantum interference device (SQUID), the experimental verification of the bipolar thermoelectric effect has been achieved, and a thermal voltage of up to ±150 µV and a Seebeck coefficient of ±300 µV/K have been demonstrated.
- **Detector design**: Based on the above - mentioned theoretical and experimental results, a single - photon detector has been designed. This detector can generate a significant thermal voltage after absorbing a single photon, thereby achieving single - photon detection.
### Formula summary
1. **Quasiparticle current formula**:
\[
I = \frac{1}{eR} \int_{-\infty}^{\infty} d\epsilon N_A(\epsilon) N_B(\epsilon + eV) [f(\epsilon, T_A) - f(\epsilon + eV, T_B)]
\]
where \( e \) is the electron charge, \( R \) is the normal - state resistance of the junction, \( V \) is the voltage drop, and \( f(\epsilon, T_i) = \left[1 + \exp\left(\frac{\epsilon}{k_B T_i}\right)\right]^{-1} \) is the Fermi - Dirac distribution function of quasiparticles.
2. **Calculation of the maximum temperature \( T_{A,M} \)**:
\[
\int_{T_A}^{T_{A,M}(\nu)} C_e(T) dT = h\nu
\]
where \( T_{\text{bath}} \) is the ambient temperature, and \( C_e(T) = T \frac{dS_A(T)}{dT} \) is the electronic heat capacity of superconductor \( S_A \).
3. **Calculation of the signal - to - noise ratio (SNR)**:
\[
\text{SNR}[T_{A,M}(\nu)] = \frac{V_{S,M}[T_{A,M}(\nu)]}{S_V \sqrt{\omega}}
\]
where \( \omega = 1 \text{ MHz} \) is the measurement bandwidth, and \( S_V = 1 \text{ nV}/\sqrt{\text{Hz}} \) is the system voltage noise spectral density.
Through these theoretical and experimental studies, the paper shows how to use the thermoelectric effect in superconducting tunnel junctions to achieve high - performance.