Abstract:With the continuous warming of the global climate, expanding the use of renewable energy has become one of the main social responsibilities. However, as the number of installed wind turbines and their physical dimensions continue to increase, the issue of generated noise has become increasingly significant in influencing the acceptance and endorsement of wind power projects by neighboring communities. In this paper, we investigated the noise generated by two wind turbine units with rated powers of 1.5 MW and 4.5 MW and analyzed the variations in low-frequency noise during their operation and shutdown periods. This research shows that the power of a single unit has a significant impact on the low-frequency noise emitted into the environment. Compared with 1.5 MW wind turbines, 4.5 MW wind turbines generate more low-frequency noise when operating at the same wind speed. Further analysis of the narrowband frequency spectra and one-third octave spectra of the measured noise indicates that the low-frequency noise from the 4.5 MW wind turbine increases significantly in the range of approximately 80 Hz to 300 Hz, with more pronounced variations below 250 Hz corresponding to changes in wind speed. However, the overall variations in low-frequency noise with wind speed are not as notable as those observed for the 1.5 MW wind turbine. Due to the relatively weak attenuation of low-frequency noise in the atmosphere, the higher low-frequency content of large wind turbines may cause more distress to residents near wind farms. The result of this study emphasizes that in the planning and design of wind power projects, in addition to considering the efficiency of single-unit power generation and the contribution of renewable energy, it is also necessary to pay full attention to noise emission issues to ensure that the project is widely supported and accepted in the community.

Noise Measurement of a Wind Turbine using Thick Blades with Blunt Trailing Edge

CHARACTERIZATION OF TRAILING EDGE BROADBAND NOISE FROM WIND TURBINE BLADES

Studies on the Experimental Measurement of the Low-Frequency Aerodynamic Noise of Large Wind Turbines

Trailing Edge Thickness Effect on Tonal Noise Emission Characteristics from Wind Turbine Blades

Noise prediction of wind turbines

Numerical Model for Noise Reduction of Small Vertical-Axis Wind Turbines

ICOPE-15-C142 Large-eddy Simulation and Wind-tunnel Measurement of the Aeroacoustics of a Horizontal-axis Wind Turbine in Different Conditions

An experimental study of tonal noise from a wind turbine airfoil with flat plate serrations

Damage Mode Identification and Singular Signal Detection of Composite Wind Turbine Blade Using Acoustic Emission

A proposed method for measuring noise from wind farms for the purpose of determining compliance with applicable limits and the comparison of results to ISO 9613-2 predictions

Acoustic Emissions from Wind Turbine Blades

Experimental investigation on noise characteristics of small scale vertical axis wind turbines in urban environments

Experimental Study on the Noise Evolution of a Horizontal Axis Icing Wind Turbine Based on a Small Microphone Array

A Feasibility Study to Reduce Infrasound Emissions from Existing Wind Turbine Blades Using a Biomimetic Technique

Aerodynamic Noise Assessment for a Vertical Axis Wind Turbine Using Improved Delayed Detached Eddy Simulation

Aerodynamic performance enhancement and noise reduction for Darrieus vertical axis wind turbines: V-shaped blades and trailing-edge serrations

Aerodynamic Noise Reduction for Small Wind Turbine Rotors

Noise Propagation Calculations of a Wind Turbine in Complex Terrain

Nacelle and Tower Effect on a Stand-Alone Wind Turbine Energy Output—a Discussion on Field Measurements of a Small Wind Turbine

Noise Reduction in Wind Turbine Airfoils with Serrated Trailing Edges: An Experimental Study in Low Turbulence Wind Tunnel

Effects of an Owl Airfoil on the Aeroacoustics of a Small Wind Turbine