Realization of a Rubidium Atomic Frequency Standard With Short-Term Stability in 10 −14 τ −1/2 Level
Jiaqi Cui,Gang Ming,Fang Wang,Junyao Li,Pengfei Wang,Songbai Kang,Feng Zhao,Da Zhong,Ganghua Mei
DOI: https://doi.org/10.1109/tim.2023.3348883
IF: 5.6
2024-01-01
IEEE Transactions on Instrumentation and Measurement
Abstract:Lamp-pumped rubidium atomic frequency standard (RAFS) is one of the most commonly utilized atomic frequency standards. Over the past few decades, the RAFS’s frequency stability performance has improved rapidly, and the best one has been in the $10^{-13} \tau ^{-1/2}$ level. In this article, we demonstrate an RAFS with stability in the $10^{-14} \tau ^{-1/2}$ level for the first time. In design of the physics package (PP), a rubidium spectral lamp with Xe as the starter gas was used as the pumping light source. The light was filtered by using optical and isotope double-filtering technique. A large slotted tube microwave cavity and a rubidium absorption cell with a diameter of 40 mm were utilized to enhance the atomic discrimination signal. A sealed box was designed for the PP to isolate it from the barometric environment. A low phase noise 6.835-GHz microwave was employed to interrogate the rubidium clock transition. Based on the quantitative analysis of the signal-to-noise ratio (SNR) of the atomic discrimination signal and the phase noise of the interrogation microwave, the stability of the RAFS was predicted to be 7.6 $\times \,\,10^{-14} \tau ^{-1/2}$ . The short-term stability of the RAFS was measured by using a hydrogen maser and an optical microwave generator (OMG) as references, and the results are 9.0 $\times \,\,10^{-14} \tau ^{-1/2}$ (1–100 s) and 9.1 $\times \,\,10^{-14} \tau ^{-1/2}$ (1–100 s), respectively. The measured results are in agreement with the predicted one.
engineering, electrical & electronic,instruments & instrumentation