Abstract:This study describes the application of new synchrotron X‐ray fluorescence (XRF) and diffraction (XRD) microtomographies for the 3‐D visualization of chemical and mineralogical variations in unsectioned extraterrestrial samples. These improved methods have been applied to three compositionally diverse chondritic meteorite samples that were between 300 and 400 μm in diameter, including samples prepared from fragments of the CR2 chondrite LaPaz Icefield (LAP) 02342, H5 chondrite MacAlpine Hills (MAC) 88203, and the CM2 chondrite Murchison. The synchrotron‐based XRF and XRD tomographies used are focused‐beam techniques that measure the intensities of fluorescent and diffracted X‐rays in a sample simultaneously during irradiation by a high‐energy microfocused incident X‐ray beam. Measured sinograms of the emitted and diffracted intensities were then tomographically reconstructed to generate 2‐D slices of XRF and XRD intensity through the sample, with reconstructed pixel resolution of 1–2 μm, defined by the resolution of the focused incident X‐ray beam. For sample LAP 02342, primary mineral phases that were visualized in reconstructed slices using these techniques included isolated grains of α‐Fe, orthopyroxene, and olivine. For our sample of MAC 88203, XRF/XRD tomography allowed visualization of forsteritic olivine as a primary mineral phase, a vitrified fusion crust at the sample surface, identification of localized Cr‐rich spinels at spatial resolutions of several micrometers, and imaging of a plagioclase‐rich glassy matrix. In the sample of Murchison, major identifiable phases include clinoenstatite‐ and olivine‐rich chondrules, variable serpentine matrix minerals and small Cr‐rich spinels. Most notable in the tomographic analysis of Murchison is the ability to quantitatively distinguish and visualize the complex mixture of serpentine‐group minerals and associated tochilinite–cronstedtite intergrowths. These methods provide new opportunities for spatially resolved characterization of sample texture, mineralogy, crystal structure, and chemical state in unsectioned samples. This provides researchers an ability to characterize such samples internally with minimal disruption of sample micro‐structures and chemistry, possibly without the need for sample extraction from some types of sampling and capture media.

Laser Scanning Confocal Microscopy of Comet Material in Aerogel

Properties of Original Impactors Estimated from Three-Dimensional Analysis of Whole Stardust Tracks

Analytical scanning and transmission electron microscopy of laboratory impacts on Stardust aluminum foils: Interpreting impact crater morphology and the composition of impact residues

Multiwavelength Ablation/Ionization and Mass Spectrometric Analysis of 1.88 Ga Gunflint Chert

Contactless Manipulation and Raman Analysis of Cometary Analogs and Micrometeorites by Acoustic Levitation

Space-filling bearings in three dimensions

Focused‐beam X‐ray fluorescence and diffraction microtomographies for mineralogical and chemical characterization of unsectioned extraterrestrial samples

Imaging Optical Fields below Metal Films and Metal-Dielectric Waveguides by a Scanning Microscope.

Application of confocal laser scanning microscopy to the study of amber bioinclusions

A Fluorescent Aerogel for Capture and Identification of Interplanetary and Interstellar Dust

Prediction of the In-Situ Dust Measurements of the Stardust Mission to Comet 81P/Wild 2

Quantitative atomic cross section analysis by 4D-STEM and EELS

Megapixel multi-elemental imaging by Laser-Induced Breakdown Spectroscopy, a technology with considerable potential for paleoclimate studies

Correlative X‐ray micro‐nanotomography with scanning electron microscopy at the Advanced Light Source

Technology Selection for Inline Topography Measurement with Rover-Borne Laser Spectrometers

Miniaturized confocal Raman and Laser-induced breakdown spectroscopy imaging system based on micro-electro-mechanical mirror

Portable confocal-controlled LIBS microscopy for topographic and LIBS mapping

Development of innovative non-destructive analytical strategies for Mars Sample Return tested on Dar al Gani 735 Martian Meteorite

Data-efficient 4D-STEM in SEM: Beyond 2D Materials to Metallic Materials

Small All-Range Lidar for Asteroid and Comet Core Missions

Scan-less 3D microscopy based on spatiotemporal encoding on a single-cavity dual-comb laser