Abstract:Tsinghua University is currently developing a very-high-frequency electron gun that operates in continuous-wave (cw) mode at 216.667 MHz. This gun will serve as the beam source for the Shanghai high repetition rate XFEL and extreme light facility. The cavity profile has been optimized to minimize input power, peak surface electric field, and peak wall power density. The profile optimization also takes into account the suppression of multipacting effect. Additionally, thermal analysis has been performed to guide the design of water cooling channels in coordination with gun mechanical design. The fabrication of the gun has been completed, and the frequency and quality factor measured in cold test are in good agreement with simulation expectations. During high power conditioning, 75 kW cw radio frequency power was successfully fed into the gun, corresponding to a cathode gradient of 27 MV/m and a gun voltage of 780 keV. This operating gradient is currently the highest in the world for room-temperature VHF guns. Under this condition, the maximum dark current collected by the Faraday cup at the gun exit was 376 nA when the strength of the gun solenoid was scanned. To measure and optimize the beam quality, a test beamline was constructed. After preliminary optimization, the 95% projected transverse emittance was 0.161 mm mrad for 10 pC bunches with a bunch length of 0.49 mm rms, 0.429 mm mrad for 50 pC bunches with a bunch length of 1.15 mm rms, and 0.853 mm mrad for 100 pC bunches with a bunch length of 1.44 mm rms.

Commissioning of the Low Energy Electron Gun Test Stand at the University of Chicago

Thermionic Sources for Electron Cooling at IOTA

Experiments On Electron Cooling and Intense Space-charge at IOTA

Beam Physics of Integrable Optics Test Accelerator at Fermilab

Improvements on the Stability and Operation of a Magnetron H- Ion Source

LEEx-B: Low Energy Experimental Bench Development at IPHC-CNRS Strasbourg

Design and Construction of a Test-Stand for the Split and Delay Line at the European XFEL

Performance analysis of the prototype THz-driven electron gun for the AXSIS project

Applications of electron lenses: scraping of high-power beams, beam-beam compensation, and nonlinear optics

Development of an L-band Photocathode RF Gun at Tsinghua University

Status Report on the Hydrodynamic Simulations of a Tapered Plasma Lens for Optical Matching at the ILC $e^+$ Source

The Integrable Optics Test Accelerator

Development and commissioning of ion-optical elements for ion and antiproton beams with energies up to 5 keV

Transverse emittance measurements on an S-band photoinjector rf electron gun

Theoretical and Simulation Study of 'Comb' Electron beam and THz generation

Commissioning Status of the Linac for the Facility for Rare Isotope Beams

Upgrades of beam diagnostics in support of emittance-exchange experiments at the Fermilab A0 photoinjector

Commissioning the Photoinjector of a Gamma-Ray Light Source

Commissioning of X-LAB: a very high-capacity X-band RF test stand facility at the University of Melbourne

Design, Fabrication, and Beam Commissioning of a 216.667 MHz Continuous-Wave Photocathode Very-High-frequency Electron Gun

Progress on the Hybrid Gun Project at UCLA