Bulk Photovoltaic Effect in Two-Dimensional Distorted MoTe2

Sikandar Aftab,Muhammad Arslan Shehzad,Muhammad Salman Ajmal,Fahmid Kabir,Muhammad Zahir Iqbal
2023-04-17
Abstract:In future solar cell technologies, the thermodynamic Shockley-Queisser limit for solar-to-current conversion in traditional p-n junctions could potentially be overcome with a bulk photovoltaic effect by creating an inversion broken symmetry in piezoelectric or ferroelectric materials. Here, we unveiled mechanical distortion-induced bulk photovoltaic behavior in a two-dimensional material (2D), MoTe2, caused by phase transition and broken inversion symmetry in MoTe2. The phase transition from single-crystalline semiconducting 2H-MoTe2 to semi-metallic 1T-MoTe2 was confirmed using X-ray photoelectron spectroscopy (XPS). We used a micrometer-scale system to measure the absorption of energy, which reduced from 800 meV to 63 meV when phase transformation from hexagonal to distorted octahedral and revealed a smaller bandgap semi-metallic behavior. Experimentally, a large bulk photovoltaic response is anticipated with the maximum photovoltage VOC = 16 mV and a positive signal of the ISC = 60 uA (400 nm, 90.4 Wcm-2) in the absence of an external electric field. The maximum values of both R and EQE were found to be 98 mAW-1 and 30 %, respectively. Our findings unveil distinctive features of the photocurrent responses caused by in-plane polarity and its potential from a wide pool of established TMD-based nanomaterials, and a novel approach to reach high efficiency in converting photons-to-electricity for power harvesting optoelectronics devices.
Materials Science,Applied Physics
What problem does this paper attempt to address?
The paper attempts to address the issue of achieving higher photoelectric conversion efficiency in two-dimensional materials to overcome the Shockley-Queisser theoretical limit in traditional pn junction solar cells. Specifically, the study induces a phase transition in molybdenum ditelluride (MoTe2) through mechanical strain, transforming it from the hexagonal symmetric 2H phase to the non-centrosymmetric 1T' phase, thereby generating the Bulk Photovoltaic Effect. This effect allows for the generation of significant photovoltage and photocurrent without an external electric field. The research team experimentally verified this phase transition process and measured its photoelectric performance. The results showed that under a 400 nm wavelength and 90.4 W/cm² laser power, the open-circuit voltage (VOC) reached 16 millivolts, and the short-circuit current (ISC) was 60 microamperes. Additionally, the maximum photoresponsivity (R) was 98 mAW⁻¹, and the maximum external quantum efficiency (EQE) was 30%. These results demonstrate the potential of using mechanical strain to control phase transitions in two-dimensional materials for efficient photoelectric conversion, providing new insights for the future development of novel solar energy conversion devices.