Abstract:The effective solution to avoid machinery damage caused by resonance has been perplexing the field of engineering as a core research direction since the resonance phenomenon was discovered by Euler in 1750. Numerous attempts have been performed to reduce the influence of resonance since the earlier of last century, by introducing a nonlinear structure or a closed-loop control system. However, the existed methodologies cannot eliminate resonance completely even extra problems were introduced inevitably, which means the technical choke-point of resonance-free remains unsolved. Here we propose a designable archetype model, which establishes a mapping between the mechanical properties and its structure. A general inverse method for structure construction is proposed based upon the required property for the system with quasi-zero stiffness of any designed finite order and the zero-stiffness properties. It is shown that an ellipse trajectory tracking of the designed model is the sufficient and necessary condition to satisfy the zero-stiffness property. Theoretical analysis shows that no resonant response happens in a zero-stiffness system to the full-band frequency excitation, or equivalently, the system can completely isolate the energy transfer between the load and environment, when the damping ratio approaches zero. Finally, an experimental rig for the prototype structure is built up according to the sufficient and necessary condition of the zero-stiffness system, for which the special dynamic behaviours are verified through experiments of frequency-sweep and random-vibration as well. Experimental results show that the prototype of the initial vibration isolation frequency of zero-stiffness system is much lower than 0.37 Hz, and the vibration attenuation of the proposed model is about 16.86 dB, 45.63 dB, and 112.37 dB at frequencies of 0.37 Hz, 1 Hz, and 10 Hz, respectively. The distinguished geometric structure of the zero-stiffness system leads to a new inspiration for the design of resonance-free in metamaterial unit and the inverse method can even adapt the design for a more targeted applications based on an arbitrary complex dynamic requirement.

Simulation and design of shaped pulses beyond the piecewise-constant approximation

Modelling of Nonlinear Dynamics for Reciprocal Multi-Layer Piezoceramic Transducer Systems

Fast and Accurate Control Strategy for <i>LCC</i> Resonant Converters Based on Simplified State Trajectory and Two-Point Solution Method

Precise Qubit Control Beyond the Rotating Wave Approximation

Numerical Analysis of Optimized Coherent Control Pulses

Optimal Control of Spin Qudits Subject to Decoherence Using Amplitude-and-Frequency-Constrained Pulses

A smoothing monotonic convergent optimal control algorithm for NMR pulse sequence design

Higher-Order Methods for Hamiltonian Engineering Pulse Sequence Design

Feedback Pulses

Robust control pulses design for electron shuttling in solid state devices

Frame Change Technique for Phase Transient Cancellation

Optimizing Qubit Control Pulses for State Preparation

Pulse Width Modulation for Simulating Time-Dependent Quantum Systems

Pulse Engineering via Projection of Response Functions

Control algorithm tests using a virtual CW SRF cavity

Optimized pulse shapes for a resonator-induced phase gate

An iteration-free approach to excitation harmonization

Control of Inhomogeneous Ensembles on The Bloch Sphere

Quantum Control Design by Lyapunov Trajectory Tracking and Optimal Control

Road to entire insulation for resonances from a forced mechanical system

Control optimization for parametric hamiltonians by pulse reconstruction