Abstract:We have developed a model that describes the major characteristics of a rupture, ranging from regular earthquakes (EQs) to slow slip events (SSEs), including episodic tremor and slip (ETS). Previous model predictions, while accurate, are based on a highly idealized initial stress distribution and a simple velocity-dependent expression for friction. The full scope of the model has, therefore, not been fully demonstrated. Further developments, presented here, include more physically realistic treatments of both the initial conditions and friction. Model predictions are: (1) The type of a seismic event, i.e. regular EQ or SSE, is determined by the fault strength, the shear to normal stress ratio, and the gradient in the ratio. Quantitative values for these crucial parameters are also obtained here; (2) Rupture velocities for regular EQs range from a fraction of the shear wave velocity up to the supershear velocity. The maximum slip velocity for regular EQs is typically on the order of 1 m/s. For SSEs, the slip velocity ranges widely from a few cm/year up to 0.1 m/s. The magnitude of the stress drop may vary in the range from 1% to 10% of the initial shear stress for regular EQs and from 0.1% to 10% for the SSEs; (3) The rupture can expend as a crack-like mode or as a self-healing pulse mode. The type of rupture mode is determined by the stress ratio and its gradient. If stress heterogeneity has a step-like shape, the rupture is always crack-like. If the heterogeneity is localized, the rupture is crack-like for sufficiently large values of the stress and its gradient and is pulse-like for smaller values; (4) After an instability develops, rupture dynamics do not depend on the relative values of the rate-state a and b parameters, i.e., it does not matter if frictional sliding is velocity-weakening or velocity-strengthening. Models based on the rate-state are not consistent with this result.

Friction Laws and Numerical Modeling of the Seismic Cycle

Complex Earthquake Cycle Simulations Using a Two-Degree-of-Freedom Spring-Block Model with a Rate- and State-Friction Law

Fractal Models of Earthquake Dynamics

Toward quantitative characterization of simulated earthquake-cycle complexities

The Positions, Colors, and Photometric Variability of Pluto's Small Satellites from HST Observations 2005-2006

Statistical Physics of Fracture, Friction and Earthquake

Estimating Fault Friction from Seismic Signals in the Laboratory

NONLINEAR DYNAMIC MODELING IN SEISMICITY ANALYSIS

Physics Models of Earthquake

Numerical Simulation on Faulting: Microscopic evolution, macroscopic interaction and rupture process of earthquakes

Finite Element Method Simulation Of The Earthquake Preparation, Occurrence, And Recurrence Cycles

Frictional state evolution laws and the non-linear nucleation of dynamic shear rupture

Earthquake dynamics constrained from laboratory experiments: new insights from granular materials

Towards a simple, comprehensive model of regular earthquakes and slow slip events, part I: one-dimensional model

Characteristics of Earthquake Cycles: A Cross-Dimensional Comparison of 0D to 3D Numerical Models

Machine Learning Predicts Earthquakes in the Continuum Model of a Rate‐And‐State Fault With Frictional Heterogeneities

The mechanisms of spatial and temporal earthquake clustering

Earthquake Cycle Modelling of Multi-segmented Faults: Dynamic Rupture and Ground Motion Simulation of the 1992 Mw 7.3 Landers Earthquake

Delayed and Fractional-order Dynamics of a model for Earthquake Induced by Stress Perturbations:

Aftershocks in a frictional earthquake model

Sheared granular matter & the empirical relations of seismicity