Abstract:We have developed a model that describes the major characteristics of a rupture, ranging from regular earthquakes (EQs) to slow slip events (SSEs), including episodic tremor and slip (ETS). Previous model predictions, while accurate, are based on a highly idealized initial stress distribution and a simple velocity-dependent expression for friction. The full scope of the model has, therefore, not been fully demonstrated. Further developments, presented here, include more physically realistic treatments of both the initial conditions and friction. Model predictions are: (1) The type of a seismic event, i.e. regular EQ or SSE, is determined by the fault strength, the shear to normal stress ratio, and the gradient in the ratio. Quantitative values for these crucial parameters are also obtained here; (2) Rupture velocities for regular EQs range from a fraction of the shear wave velocity up to the supershear velocity. The maximum slip velocity for regular EQs is typically on the order of 1 m/s. For SSEs, the slip velocity ranges widely from a few cm/year up to 0.1 m/s. The magnitude of the stress drop may vary in the range from 1% to 10% of the initial shear stress for regular EQs and from 0.1% to 10% for the SSEs; (3) The rupture can expend as a crack-like mode or as a self-healing pulse mode. The type of rupture mode is determined by the stress ratio and its gradient. If stress heterogeneity has a step-like shape, the rupture is always crack-like. If the heterogeneity is localized, the rupture is crack-like for sufficiently large values of the stress and its gradient and is pulse-like for smaller values; (4) After an instability develops, rupture dynamics do not depend on the relative values of the rate-state a and b parameters, i.e., it does not matter if frictional sliding is velocity-weakening or velocity-strengthening. Models based on the rate-state are not consistent with this result.

[Lymphatic system: morphology and pathology update].

Systemic-to-pulmonary venous shunt in superior vena cava obstruction.

Finite Element Method Simulation Of The Earthquake Preparation, Occurrence, And Recurrence Cycles

Coupling 3D geodynamics and dynamic earthquake rupture: fault geometry, rheology and stresses across timescales

Towards a simple, comprehensive model of regular earthquakes and slow slip events, part I: one-dimensional model

Comparing Earthquake Cycles on Normal and Reverse Faults Based on Simulations With a Dynamic Elasto‐Plastic Model

Scaling of Earthquake Models with Inhomogeneous Stress Dissipation

Intrinsic Properties of a Burridge-Knopoff Model of an Earthquake Fault.

Kinematic Earthquake Sequences on Geometrically Complex Faults

Complex Earthquake Cycle Simulations Using a Two-Degree-of-Freedom Spring-Block Model with a Rate- and State-Friction Law

Inhomogeneity effects on earthquake fault events

Different Earthquake Patterns for Two Neighboring Fault Segments Within the Haiyuan Fault Zone

Numerical Simulation on Faulting: Microscopic evolution, macroscopic interaction and rupture process of earthquakes

A Multidimension Source Model for Generating Broadband Ground Motions with Deterministic 3D Numerical Simulations

Earthquake breakdown energy scaling despite constant fracture energy

A comparative study on the self-similarity hypothesis of regular and slow earthquake growth

Laboratory Earthquakes Simulations—Emergence, Structure, and Evolution of Fault Heterogeneity

Interoccurrence time statistics in the two-dimensional Burridge-Knopoff earthquake model

Simple Spring-mass Model Simulation of Earthquake Cycle along the Nankai Trough in Southwest Japan

Fractal Models of Earthquake Dynamics

Depth Dependence of Coseismic Off-Fault Damage and its Effects on Rupture Dynamics