A Novel Koopman-Inspired Method for the Secondary Control of Microgrids with Grid-Forming and Grid-Following Sources

Xun Gong,Xiaozhe Wang

DOI: https://doi.org/10.48550/arXiv.2301.01461

2023-01-04

Abstract:This paper proposes an online data-driven Koopman-inspired identification and control method for microgrid secondary voltage and frequency control. Unlike typical data-driven methods, the proposed method requires no warm-up training yet with guaranteed bounded-input-bounded-output (BIBO) stability and even asymptotic stability under some mild conditions. The proposed method estimates the Koopman state space model adaptively so as to perform effective secondary voltage and frequency control that can handle microgrid nonlinearity and uncertainty. Case studies in the 4-bus and 13-bus microgrid test systems (with grid-forming and grid-following sources) demonstrate the effectiveness and robustness of the proposed identification and control method subject to the change of operating conditions and large disturbances (e.g., microgrid mode transitions, generation/load variations) even with measurement noises and time delays.

Systems and Control

What problem does this paper attempt to address?

This paper attempts to solve the problems of frequency and voltage recovery in microgrids (MGs) when facing large disturbances or mode transitions (e.g., from grid - connected to islanded mode). Specifically:

1. **Problem Background**:
- Due to the low - inertia characteristics of microgrids and the fact that the interfaces of distributed energy resources (DERs) are implemented through power converters, their frequencies and voltages are easily affected by power generation and load fluctuations.
- Although existing control methods (such as primary control based on droop characteristics) can coordinate the power output of DERs to a certain extent, they may not completely eliminate frequency and voltage deviations at the system level, especially when facing large disturbances.

2. **Research Objectives**:
- Propose a new data - driven Koopman - heuristic identification and control method for secondary voltage and frequency control in microgrids.
- This method aims to deal with nonlinearity and uncertainty in microgrids, especially in the case of mode transitions (such as from grid - connected to islanded mode) and power generation/load changes.

3. **Main Challenges**:
- **Nonlinearity and Uncertainty**: When facing large disturbances, the dynamic behavior of the microgrid system becomes complex and difficult to predict.
- **Hybrid Control Structure**: There are both grid - forming and grid - following types of DERs in the microgrid, which increases the complexity and uncertainty of the system.
- **Model Dependence**: Traditional control methods rely on accurate physical models, but these models may be difficult to obtain or maintain accuracy in practical applications.

4. **Solutions**:
- Use Koopman operator theory to transform the nonlinear dynamic system into a linear system, so that mature linear system techniques can be used for identification and control.
- Propose an improved OKID (Observer Kalman - filter IDentification) algorithm, which can perform online identification using only a short segment of synchrophasor data (such as micoPMUs data) without relying on offline training.
- Apply the discrete - time linear quadratic regulator (LQR) to control the identified Koopman linear dynamic system to ensure the bounded - input - bounded - output (BIBO) stability and asymptotic stability of the system.

5. **Advantages**:
- **No Offline Training Required**: This method does not require pre - training and has strong adaptability.
- **Robustness**: It can deal with measurement noise and time delays and shows good robustness in numerical studies.
- **Stability Guaranteed**: The system has BIBO stability and asymptotic stability under certain mild conditions.

In conclusion, the method proposed in this paper aims to solve the frequency and voltage recovery problems in microgrids when facing large disturbances in a data - driven manner, and is especially suitable for microgrid systems containing grid - forming and grid - following sources.