Abstract:The design and construction of carbon nanotubes (CNT)-based thermoelectric materials are benefit for developing self-powered wearable devices. Molybdenum disulfide (MoS 2 ) with few layers has been pursued to enhance the thermoelectric properties of CNT due to its high carrier mobility and energy filtering effect. In this work, sulfhydryl silica nanoparticles were firstly synthesized as a concomitant sulfur source, and the SiO 2 @MoS 2 with few layers was prepared by hydrothermal method. By light doping SiO 2 @MoS 2 with few layers, the carrier mobility of the SiO 2 @MoS 2 /SWCNT is further improved due to the enhanced interfacial interaction between MoS 2 and SWCNTs, and the Seebeck coefficient was improved obviously without significant decrease in electrical conductivity, thus improving the power factor ( PF ) of the SWCNTs. Here, the maximum Seebeck coefficient, electrical conductivity, and PF values for SiO 2 @MoS 2 /SWCNT obtained at room temperature were 39.2 ± 0.2 μV K −1 , 1646.4 ± 117.2 S cm −1 and 253.2 ± 21.1 μW m −1 K −2 , respectively. In addition, the PF was further enhanced to 303.3 μW m −1 K −2 at 435 K. Moreover, a thermoelectric device was assembled by connecting SiO 2 @MoS 2 /SWCNT films and copper sheets in series, which exhibited an open circuit voltage of 11.2 mV and an output power of 1.1 μW under a temperature gradient of 50 K. Therefore, this work opens a novel avenue for fabricating CNT-based thermoelectric materials with high performance, which has potential application in converting heat energy into electrical power at middle-low temperature.

Single-material MoS$_{2}$ thermoelectric junction enabled by substrate engineering

Large Thermoelectricity via Variable Range Hopping in Chemical Vapor Deposition Grown Single-layer MoS2

A thin film efficient pn-junction thermoelectric device fabricated by self-align shadow mask

Multiphysics Modeling and Simulation of Carrier Dynamics and Thermal Transport in Monolayer MoS2/WSe2 Heterojunction

High Thermoelectric Powerfactor in Single and Few-Layer MoS_2

High Thermoelectric Powerfactor in Single and Few-Layer MoS$_2$

Realizing P-Type MoS2 with Enhanced Thermoelectric Performance by Embedding VMo2S4 Nanoinclusions

Tuning the thermoelectric properties of ZnO/MoS2/carbon fabric via interface-induced energy filtering effect for wearable thermoelectric application

Large enhancement of thermoelectric performance in MoS2/h-BN heterostructure due to vacancy-induced band hybridization.

Atomically Flat Dielectric Patterns for Band Gap Engineering and Lateral Junction Formation in MoSe$_2$ Monolayers

Unravelling the Thermoelectric Properties and Suppression of Bipolar Effect under Strain Engineering for the Asymmetric Janus SnSSe and PbSSe Monolayers

Environment-insensitive and gate-controllable photocurrent enabled by bandgap engineering of MoS2 junctions

Large and tunable photo-thermoelectric effect in single-layer MoS2

Large enhancement of thermoelectric performance in MoS<sub>2</sub>/<i>h</i>-BN heterostructure due to vacancy -induced band hybridization

High Thermoelectric Powerfactor in 2D Crystals of MoS 2

Silica-modified few-layered MoS 2 for SWCNT-based thermoelectric materials

High-Performance MoS 2 /SWCNT Composite Films for a Flexible Thermoelectric Power Generator

Solution-processed Two-Dimensional Layered Heterostructure Thin-Film with Optimized Thermoelectric Performance

Molecular design and control of fullerene-based bi-thermoelectric materials

Two-Dimensional Mechano-thermoelectric Heterojunctions for Self-Powered Strain Sensors

Enhanced Thermoelectric Performance of Two Dimensional MS2 (M = Mo, W) Through Phase Engineering