Fabrication and optimization of perovskite-based photoanodes for solar-driven CO 2 photoelectroreduction to formate

José Antonio Abarca,Ivan Merino-Garcia,Guillermo Díaz-Sainz,Maite Perfecto-Irigaray,Garikoitz Beobide,Angel Irabien,Jonathan Albo
DOI: https://doi.org/10.1016/j.cattod.2023.114505
IF: 5.3
2024-01-04
Catalysis Today
Abstract:The photoelectrochemical reduction of CO 2 to value-added products represents a promising strategy for mitigating CO 2 emissions. However, further research efforts need to be undertaken to enable the technology for scale-up, including the design and fabrication of efficient photoelectrodes capable of yielding substantial photogenerated current densities. In this work, a photoanode combining a commercial calcium titanate perovskite (CaTiO 3 ) and BiVO 4 layers coated onto a transparent FTO substrate by automated spray pyrolysis is proposed. Different photoanode configurations are tested, with the most favourable results achieved when BiVO 4 is positioned as the top layer with back illumination. The optimization of the catalytic loading is also assessed, finding an optimal at 1 mg cm -2 of CaTiO 3 and 3 mg cm -2 of BiVO 4 , resulting in an impressive current density of –71 mA cm -2 at –1.8 V vs. Ag/AgCl. This optimal photoanode is then integrated into an electrolyzer for continuous visible light-driven CO 2 reduction in the gas phase to formate, obtaining a concentration of 63.8 g L -1 , with a Faradaic Efficiency of 79.1%, and solar-to-fuel conversion efficiency of 7.6%. These results represent a significant advancement in the development of photoanodes, offering promise for the future scalability of photoelectrochemical CO 2 reduction processes.
chemistry, physical,engineering, chemical, applied
What problem does this paper attempt to address?