Abstract:A novel microfluidic picoliter-scale sample introduction approach was developed by combining the spontaneous injection approach with a capillary electrophoresis (CE) system based on a short capillary and slotted-vial array. A droplet splitting phenomenon at the capillary inlet end during the spontaneous sample introduction process was observed for the first time. On the basis of this phenomenon, a translational spontaneous injection approach was established to reduce sample injection volumes to the sub-100 pL range. A versatile high-speed capillary electrophoresis (HSCE) system was built on the basis of this sample injection approach with separation performance comparable to or even better than those reported in microfluidic chip-based CE systems. The HSCE system was composed of a short fused-silica capillary and an automated sample introduction system with slotted sample and buffer reservoirs and a computer-programmed translational stage. The translational spontaneous sample injection was performed by linearly moving the stage, allowing the capillary inlet first to enter the sample solution and then removing it. A droplet was left at the tip end and spontaneously drawn into the capillary by surface tension effect to achieve sample injection. The stage was continuously moved to allow the capillary inlet to be immersed into the buffer solution, and CE separation was performed by applying a high voltage between the buffer and waste reservoirs. With the use of the novel system, high-speed and efficient capillary zone electrophoresis (CZE) separation of a mixture of five fluorescein isothiocyanate (FITC) labeled amino acids was achieved within 5.4 s in a short capillary with a separation length of 15 mm, reaching separation efficiencies up to 0.40 microm plate height. Outstanding peak height precisions ranging from 1.2% to 3.7% RSD were achieved in 51 consecutive separations. By extension of the separation length to 50 mm, both high-speed and high-resolution CZE separation of eight FITC-labeled amino acids could be obtained in less than 21 s with theoretical plates ranging from 163,000 to 251,000 (corresponding to 0.31-0.20 microm plate heights). The present HSCE system also allowed fast chiral separations of FITC-labeled amino acids under micellar electrokinetic chromatography (MEKC) mode within 6.5 s.

A simple cellulose acetate membrane-based small lanes technique for protein electrophoresis

Self-assembled and Covalently Linked Capillary Coating of Diazoresin and Cyclodextrin-Derived Dendrimer for Analysis of Proteins by Capillary Electrophoresis

High‐speed Separation of Proteins by Sodium Dodecyl Sulfate‐capillary Gel Electrophoresis with Partial Translational Spontaneous Sample Injection

Fast Preparation And Evaluation Of Cross-Linked And Surface Boned Polyacrylamide Coated Column For Capillary Electrophoresis

Photopatterned free-standing polyacrylamide gels for microfluidic protein electrophoresis

Droplet sample introduction to microchip gel and zone electrophoresis for rapid analysis of protein-protein complexes and enzymatic reactions

Carrier ampholyte-free isoelectric focusing on a paper-based analytical device for the fractionation of proteins

Development of a gel monolithic column polydimethylsiloxane microfluidic device for rapid electrophoresis separation.

Open microfluidic gel electrophoresis: Rapid and low cost separation and analysis of DNA at the nanoliter scale

Protein characterization by on-line capillary isoelectric focusing, reversed-phase liquid chromatography, and mass spectrometry.

Microfluidic Picoliter-Scale Translational Spontaneous Sample Introduction for High-Speed Capillary Electrophoresis

Dynamic coating using methylcellulose and polysorbate 20 for nondenaturing electrophoresis of proteins on plastic microchips

Preparation of Hydroxypropyl Cellulose-Poly (2-Methacryloyloxyethyl Phosphorylcholine) Coating for the Analysis of Proteins by Capillary Electrophoresis

SDS-PAGE focusing: preparative aspects

Novel Diazoresin/carboxymethyl Chitosan Capillary Coating for the Analysis of Proteins by Capillary Electrophoresis

Analysis of proteins by capillary electrophoresis with a novel diazoresin/beta-Cyclodextrin covalent capillary coating method

Microscale 2D separation systems for proteomic analysis

Capillary isoelectric focusing coupled with dynamic imaging detection: A one-dimensional separation for two-dimensional protein characterization.

Rapid Enrichment of a Native Multipass Transmembrane Protein via Cell Membrane Electrophoresis through Buffer pH and Ionic Strength Adjustment

Continuous Separation of Proteins by Multichannel Flow Electrophoresis

On-line Electrophoretic Sample Clean-Up for Sensitive and Reproducible Μce Immunoassay.