Abstract:International Journal of Structural Stability and Dynamics, Ahead of Print. In this paper, we solve the vibration problem of a finite bar with a viscously damped boundary in conjunction with a spring on the same side subject to the support motion on the other side. To avoid the computation of complex modes and the difficulty of orthogonal conditions for the partial differential equation (PDE) of a continuous system, two alternatives are employed. One is the analytical derivation by using the diamond rule of the method of characteristics. The advantage is that this method can yield an analytical solution. However, the disadvantage is that the method can be only applied to some simple problems such as a linear system and the one-dimensional (1D) wave equation. The other numerical method, finite element method (FEM), is incorporated into a general-purpose program to solve this problem. The advantage of the FEM is that this methodology can be applied to solve various problems such as different PDEs. Therefore, the solution obtained by using the FEM is compared with that of the analytical solution. Two special cases, only a spring and a damper alone, are also considered by using the FEM. Interestingly, the same silent area is captured in the displacement profile by using the FEM for the three cases. We also find that the displacement profiles have slope discontinuity which only occurs on the characteristic line. After the wave front arrives at the boundary, various responses appear due to different boundaries, spring, damper and both. It is found that the displacement amplitude of the general case is smaller than the other two special cases. This result matches the application of engineering practice.

Simulation of Two-Degree-of-Freedom Damped Dynamic Vibration Absorber Based on Simulink

The Application of Sensitivity Method in Vehicle Dynamics Analysis

Finite Element Modeling of Nonlinear Active and Passive Dampers Applied to Vibration Controls

Study on tuning methodologies of passive vibration absorbers

Steady-state responses of mechanical system attached to non-smooth vibration absorber with piecewise damping and stiffness

Mathematical Modeling and Experimental Evaluation of an Air Spring–Air Damper Dynamic Vibration Absorber

Control and Simulation of Semi-Active Suspension Based on MRF Damper

A DVA-Beam Element for Dynamic Simulation of DVA-Beam System: Modeling, Validation and Application

Multi-body-Simulation of a Self Adaptive Torsional Vibration Absorber

Dynamic Analysis of the Behavior of a Pendulum Damper with Mobile Suspension Point

Simulation and Optimization of Hydraulic Shock Absorber Based on AMESim/Matlab

Analysis of non-linear dynamics of a two-degree-of-freedom vibration system with non-linear damping and non-linear spring

Time domain analysis of structures with hysteretic vibration suppression systems

Modeling and simulation of non-linear and hysteresis behavior of magneto-rheological dampers in the example of quarter-car model

Study of Support Motion of a Finite Bar with a Boundary Damper and a Spring Using Analytical Approaches and FEM

Modeling and Vibration Decoupling Control of Multi-Axial Shaking Table

Analysis of the dynamic behavior of a vehicle with fully independent double-wishbone suspension and anti-roll bars

Study on Dynamic Simulation of Subminiature Car Between Model of Seven DOF and Eight DOF

Study and Simulation of Vehicle Suspension System

Simulation study on vibration reduction characteristics of two-degree of freedom suspension system in a quarter vehicle

Vehicle Dynamics Modeling for Simulator of Vehicle Driver Assistant Systems