Abstract:This work assesses the effect of using different closure concepts for the spatially filtered mean reaction rate on the resolved spectral response of turbulent heat release in large eddy simulations (LESs). Two well-known combustion models, the turbulent flame speed closure (TFC) and the dynamically thickened flame (DTF) models have been applied to a premixed turbulent jet flame with otherwise identical numerical setups. Although the flame front is artificially thickened in the DTF model, it reproduces a thinner flame and, hence, stronger flame–turbulence interactions compared to the TFC model. As the time-averaged quantities from both methods are comparable, the DTF approach shows overall higher fluctuations of local and integral heat release rates in the spectral domain compared to the TFC model, particularly in the high-frequency range. A better agreement with measured sound pressure density is observed for TFC in the low-frequency range and for DTF in the high-frequency range. TFC simulations with different source formulations, that is, , showed comparable flame thicknesses and spectra of heat release, but the averaged flow quantities calculated with , however, deviate largely from measured data for the current setup. In the second step, the same formulations for the mean rate are applied to an excited plane-jet flame (two-dimensional (2D)) using equidistant grid cells and forced inflow conditions, thereby excluding the influence of varying grid resolution and broadband turbulent fluctuations. This setup is specifically tailored for a detailed analysis of flame response to flow unsteadiness and grid resolution. The formulation of the reaction rate according to the TFC approach again results in a considerably thicker flame compared to results obtained from the DTF model and direct numerical simulation, even on a sufficiently fine mesh. Therefore, the DTF formulation of the reaction rate shows overall stronger responses of heat release rates to forced fluctuations than the TFC formulation. Differences are smaller in the low-frequency range, indicating a stronger damping of heat release fluctuations with increasing frequency for the TFC formulation. Coarsening the grid leads to a much stronger damping of heat release fluctuations in the DTF formulation compared with the TFC formulation, so that the benefit of the DTF formulation decreases with decreasing grid resolution. This reflects the different sensitivity behavior of these models with respect to unsteady flows and grid resolutions, which is of great importance for computing thermoacoustic problems with LES, for example, combustion noise.

Modelling the response of a turbulent jet flame to acoustic forcing in a linearized framework using an active flame approach

Large Eddy Simulation/dynamic Thickened Flame Modeling of a High Karlovitz Number Turbulent Premixed Jet Flame

Performance assessment of flamelet models in flame-resolved LES of a high Karlovitz methane/air stratified premixed jet flame

Large-Eddy Simulation of Premixed Methane/Air Jet Flames

A Direct Numerical Simulation Study of Flame Structure and Stabilization of an Experimental High Ka CH4/air Premixed Jet Flame

Turbulence-flame interactions in DNS of a laboratory high Karlovitz premixed turbulent jet flame

Impact of Combustion Modeling on the Spectral Response of Heat Release in LES

Low-Order Modelling of the Response of Ducted Flames in Annular Geometries

Computational investigations of the coupling between transient flame dynamics and thermo-acoustic instability in a self-excited resonance combustor

Turbulent Accelerating Combusting Flows with a Methane-Vitiated Air Flamelet Model

Linear amplification of inertial-wave-driven swirl fluctuations in turbulent swirling pipe flows: a resolvent analysis approach

Linear and nonlinear flame response prediction of turbulent flames using neural network models

Dynamics and control of premixed combustion systems based on flame transfer and describing functions

A parsimonious system of ordinary differential equations for the response modeling of turbulent swirled flames

Turbulent Accelerating Combusting Flows with Methane-Vitiated Air Flamelet Model

Network- and CFD/CAA-modelling of the high frequency flame response in multi-jet combustors

Linear control of thermoacoustic oscillations with flame dynamics modeled by a level-set method

Global linear stability analysis of a slit flame subject to intrinsic thermoacoustic instability

Dynamic Response of Stratified Flames to Acoustic Excitation in a Multi-Swirler Model Combustor

Reynolds-average Navier-Stokes turbulence models assessment: A case study of CH4/H2/N2-air reacting jet

Large eddy simulation of flame and thermal-acoustic characteristic in a strut-based scramjet with dynamic thickened flame model