Abstract:In this work, we, for the first time, observed the remarkable thermoelectric properties of a few high-quality PtSe2 layered films fabricated by a post selenization of Pt thin films. An excellent power factor of ≳200 μW/mK2 with a Seebeck coefficient of >100 μV/K in the PtSe2 layered film of 10 layers can be experimentally demonstrated over a wide temperature range, which is much better than those of most of the two-dimensional materials reported in the literature. Optical absorption spectra and DFT (density functional theory) calculations indicate a semiconductor–metal transition at a critical thickness once the thickness increases from 7.7 (15 layers) to 14.3 nm (30 Layers). The results are consistent with the experimental results of the dramatic reduction in the power factor, the magnitude of the Seebeck coefficient, and the resistivity when the thickness increases from 7.7 (15 layers) to 14.3 nm (30 Layers). Nevertheless, the semiconductor–metal transition would occur when the thickness increases from 1.5 nm (3 layers) to 2 nm (4 layers). To figure out this unusual performance, a detailed material examination has been conducted. After the transmission electron microscopy examination, ∼7% biaxial compressive strain built in the polycrystalline PtSe2 thin film can be observed. The strain, as revealed by our DFT calculations, plays an important role in opening the electronic energy gap and hence significantly improves the thermoelectric performance. Boltzmann transport calculation results suggested that both the strain and the hole concentration in the p-type specimens are well optimized. We further propose that an even better power factor can be achieved with n-type-doped PtSe2.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.chemmater.0c04351?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.chemmater.0c04351</a>.Detailed experimental sections; TEM image of a PtSe2 layered film with a thickness of 25.5 nm (50 layers); EDS analysis of the PtSe2 layered film with a thickness of 25.5 nm (50 layers); thickness dependence of the electronic gap; schematic of thermoelectric measurements; in situ XRD results of PtSe2 layered film with a thickness of 5 nm (10 layers); thermoelectric properties as a function of Fermi level; and determination of the Fermi level position (<a class="ext-link" href="/doi/suppl/10.1021/acs.chemmater.0c04351/suppl_file/cm0c04351_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Stacking polymorphism in PtSe$_2$ drastically affects its electromechanical properties

Stacking Polymorphism of PtSe$_{2}$: Its Implication to Layer-dependent Metal-insulator Transitions

Highly sensitive electromechanical piezoresistive pressure sensors based on large-area layered PtSe$_{2}$ films

Evolution of interlayer stacking orders and rotations in bilayer PtSe 2 visualized by STEM

Mechanical Characterization of Stacked Single‐Crystal of Polyethylene and Monolayer MoSe2

Correlating Nanocrystalline Structure with Electronic Properties in 2D Platinum Diselenide

Edge conductivity in PtSe$_2$ nanostructures

Electronic properties, stability, and lattice thermal conductivity of bulk Janus 3R-PtXY (X, Y=S, Se, Te) transition-metal dichalcogenide

Stacking Pattern Induced High ZTs in Monolayer SnSSe and Bilayer SnXY (X/Y = S, Se) Materials with Strong Anharmonic Phonon Scattering

Phonon dynamics and thermal conductivity of PtSe2 thin films: Impact of crystallinity and film thickness on heat dissipation

Thermally Strain-Induced Band Gap Opening on Platinum Diselenide-Layered Films: A Promising Two-Dimensional Material with Excellent Thermoelectric Performance

Stacking sequence determines Raman intensities of observed interlayer shear modes in 2D layered materials - A general bond polarizability model

Tuning the optoelectronic properties of PtS2/PtSe2 heterostructure via strain engineering

Direct visualization of stacking-selective self-intercalation in epitaxial Nb1+xSe2 films

Direct observation of the interplay between stacking polytypes and self-intercalation in epitaxial Nb1+xSe2 films

Global structure search for new 2D PtSSe allotropes and their potential for thermoelectirc and piezoelectric applications

First-Principles Study of Structural and Electronic Properties of Monolayer PtX2 and Janus PtXY (X, Y = S, Se, and Te) via Strain Engineering

Complex and Noncentrosymmetric Stacking of Layered Metal Dichalcogenide Materials Created by Screw Dislocations.

Stacking-Dependent Interlayer Magnetic Interactions in CrSe 2

Expanded stability of layered SnSe-PbSe alloys and evidence of displacive phase transformation from rocksalt in heteroepitaxial thin films

First-principles Calculations of MoSeTe/WSeTe Bilayers: Stability, Phonons, Electronic Band Offsets, and Rashba Splitting