Abstract:In this work, we, for the first time, observed the remarkable thermoelectric properties of a few high-quality PtSe2 layered films fabricated by a post selenization of Pt thin films. An excellent power factor of ≳200 μW/mK2 with a Seebeck coefficient of >100 μV/K in the PtSe2 layered film of 10 layers can be experimentally demonstrated over a wide temperature range, which is much better than those of most of the two-dimensional materials reported in the literature. Optical absorption spectra and DFT (density functional theory) calculations indicate a semiconductor–metal transition at a critical thickness once the thickness increases from 7.7 (15 layers) to 14.3 nm (30 Layers). The results are consistent with the experimental results of the dramatic reduction in the power factor, the magnitude of the Seebeck coefficient, and the resistivity when the thickness increases from 7.7 (15 layers) to 14.3 nm (30 Layers). Nevertheless, the semiconductor–metal transition would occur when the thickness increases from 1.5 nm (3 layers) to 2 nm (4 layers). To figure out this unusual performance, a detailed material examination has been conducted. After the transmission electron microscopy examination, ∼7% biaxial compressive strain built in the polycrystalline PtSe2 thin film can be observed. The strain, as revealed by our DFT calculations, plays an important role in opening the electronic energy gap and hence significantly improves the thermoelectric performance. Boltzmann transport calculation results suggested that both the strain and the hole concentration in the p-type specimens are well optimized. We further propose that an even better power factor can be achieved with n-type-doped PtSe2.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.chemmater.0c04351?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.chemmater.0c04351</a>.Detailed experimental sections; TEM image of a PtSe2 layered film with a thickness of 25.5 nm (50 layers); EDS analysis of the PtSe2 layered film with a thickness of 25.5 nm (50 layers); thickness dependence of the electronic gap; schematic of thermoelectric measurements; in situ XRD results of PtSe2 layered film with a thickness of 5 nm (10 layers); thermoelectric properties as a function of Fermi level; and determination of the Fermi level position (<a class="ext-link" href="/doi/suppl/10.1021/acs.chemmater.0c04351/suppl_file/cm0c04351_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Correlating Nanocrystalline Structure with Electronic Properties in 2D Platinum Diselenide

Electrical characterization of structured platinum diselenide devices

Metal-Organic Chemical Vapor Deposition of PtSe2

Electrical devices from top-down structured platinum diselenide films

Anisotropic Spectroscopy and Electrical Properties of 2D ReS2(1–x)Se2x Alloys with Distorted 1T Structure

Scalable Metal–Organic Chemical Vapor Deposition of High Quality PtSe2

Homogeneous Platinum Diselenide Metal/semiconductor Coplanar Structure Fabricated by Selective Thickness Control.

Unveiling the Layer‐Dependent Catalytic Activity of PtSe2 Atomic Crystals for the Hydrogen Evolution Reaction

Precise Layer‐Dependent Electronic Structure of MBE‐Grown PtSe2

Anisotropic electrical properties of aligned PtSe2 nanoribbon arrays grown by a pre-patterned selective selenization process

Edge conductivity in PtSe$_2$ nanostructures

Atomic Structure of Dislocations and Grain Boundaries in Two-Dimensional PtSe 2

Intense second-harmonic generation in two-dimensional PtSe 2

Thermally Strain-Induced Band Gap Opening on Platinum Diselenide-Layered Films: A Promising Two-Dimensional Material with Excellent Thermoelectric Performance

Crystalline Orientation‐Tunable Growth of Hexagonal and Tetragonal 2H─PtSe2 Single‐Crystal Flakes

Phase Variations and Layer Epitaxy of 2D PdSe 2 Grown on 2D Monolayers by Direct Selenization of Molecular Pd Precursors

Monolayer Ptse2, A New Semiconducting Transition-Metal-Dichalcogenide, Epitaxially Grown by Direct Selenization of Pt

Janus Doping of Sulfur into Platinum Diselenide Ribbons

Two-Dimensional Platinum Diselenide: Synthesis, Emerging Applications, and Future Challenges

Optical properties of thickness-controlled PtSe<sub>2</sub> thin films studied <i>via</i> spectroscopic ellipsometry

Two‐Dimensional Palladium Diselenide with Strong In‐Plane Optical Anisotropy and High Mobility Grown by Chemical Vapor Deposition