Abstract:Recent developments in multiplication circuits with fewer transistors, higher speed, and reduced energy consumption are lowering hardware costs. Approximate multiplication is used for fault-tolerant applications, such as image and signal processing. These applications offer considerable improvement at the cost of reduced accuracy. Compressors are the main component of any multiplier structure. In this work, the design of an approximate multiplier based on current mode, using 4:2 and 5:2 approximate compressors and current over scaling technique is suggested to reduce power consumption, delay, and hardware components compared to existing architectures. In the proposed approach for the design of compressor circuits, current mode binary converters with 32 nm CNTFET technology are used. This work is done in three steps: (1) converting input currents into voltage and creating multi-level voltages. (2) Implementing voltage level detector. (3) Generation of output current based on threshold voltage. The proposed technique uses less number of transistors. The simulation was done under HSPICE software and the efficiency of the compressors was compared in terms of delay, power, and power delay product (PDP). Based on the simulation results, the PDP value for 4:2 and 5:2 compressor circuits is calculated as 0.0097 and 0.0131 fJ, respectively. Then, an approximate multiplication of 8 × 8 using these compressors is designed for multiplying images under MATLAB software. This multiplier has achieved a good improvement in terms of PSNR and MSSIM (respectively 9.14 and 2.85%) compared to advanced approximate multipliers. Also, the proposed approach performs better in terms of accuracy, power consumption, and delay.

Spin Wave Based Approximate 4:2 Compressor

Spin Wave Based 4-2 Compressor

FinFET-based Low-power Improved PDP 4:2 Approximate Compressor Design

An Introduction to Spin Wave Computing

Achieving Wave Pipelining in Spin Wave Technology

An Optimized Compression Strategy for Compressor-Based Approximate Multiplier

Spin Wave Threshold Gate

Efficient Approximate Multiplier Based on a New 1-Gate Approximate Compressor

Image Multiplication Using Novel 4:1 Approximate Compressor*

Spin-Based Computing: Device Concepts, Current Status, and a Case Study on a High-Performance Microprocessor

Boolean and Non-Boolean Computation With Spin Devices

A fast and energy-efficient hybrid 4–2 compressor for multiplication in nanotechnology

A Proposal for Energy-Efficient Cellular Neural Network based on Spintronic Devices

Hardware-accuracy trade-offs for error-resilient applications using an ultra-efficient hybrid approximate multiplier

Experimental prototype of a spin-wave majority gate

A Novel Current Mode Approximate Multiplier Scheme Based on 4:2 and 5:2 Compressors with Low Power Consumption and High Speed in CNTFET Technology

Design of a CMOS integrated on-chip oscilloscope for spin wave characterization

Power-Area Efficient Serial IMPLY-based 4:2 Compressor Applied in Data-Intensive Applications

Simplified Compressor and Encoder Designs for Low-Cost Approximate Radix-4 Booth Multiplier

Design and Analysis of Approximate 4–2 Compressors for High-Accuracy Multipliers

Comparison and design of energy-efficient approximate multiplier schemes for image processing by CNTFET